1) safety relief amount
泄放量
1.
A collection of safety relief amount calculation standards is made and a further detailed discussion based on the collection is developed,discussing questions encountered during calculation.
对国内安全阀安全泄放量的计算进行了归纳,在此基础上,针对安全阀安全泄放量计算中容器外壁修正系数、容器受热面积、汽化潜热和压缩因子等方面存在的问题进行了较为深入的探讨。
2) aggregate relieving capacity
总泄放量
3) maximum relief capacity
最大泄放量
1.
Determination of maximum relief capacity of PSV of a crude oil vessel under fire case is always a difficult engineering problem because of lack of necessary research tools.
对于原油容器安全阀在火灾工况下最大泄放量的确定,由于缺少必要的研究工具,历来都是工程计算中的难题。
4) safety discharge
安全泄放量
1.
As for the large seamless steel pressure vessel, how to install the safety relief device and to calculate the safety discharge, it usually based on the special method and formula required in GB150-1998, JB4732-1995 and Safety Technology Supervision Regulation of Pressure Vessel.
大容积钢质无缝压力容器安全泄放装置的设置和安全泄放量的计算,按照国内标准应该采用GB150-1998、JB4732-1995和《压力容器安全技术监察规程》规定的方法和公式进行计算,但对于容器处于火灾环境时,安全泄放量的计算没有给出明确的方法,本文针对此问题进行了论述和探讨。
5) rated relieving capacity
额定泄放量
6) relief amount calculation
泄放量计算
1.
Safety relief amount calculation for pressure vessel was introduced with the operating pressures,operating temperatures, properties of working medium, such as latent heat of vaporization and compress factor etc.
介绍了压力容器在操作压力、操作温度、容器外壁修正系数、容器受热面积、工作介质性质、例如介质汽化潜热和压缩因子等与经济性时的安全泄放量计算。
补充资料：掣掣泄泄
1.随风飘荡貌。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条