1) two-winged fishbone-shaped model
双翼鱼刺型模型
2) dual wings fishbone-shaped model
双翼鱼刺型振动模型
1.
This paper analyzes planar steel-frame construction by nonlinear static procedure,and proposes a new kind of structure model called dual wings fishbone-shaped model with the aid of the incremental coefficient λ.
对于平面钢框架结构,应用非线性静力分析法,借助于增值系数λ,提出了新的结构振动模型——双翼鱼刺型振动模型。
3) fish-stab diagram model
鱼刺图模型
1.
Based on accident analysis, a systematical and comprehensive cause-effect fish-stab diagram model for these accidents is put forward.
通过对老空水水害事故的分析,建立了一个系统全面的老空水水害事故的致因鱼刺图模型;并针对鱼刺图模型的各个致因事件提出了老空水防治的具体措施;然后根据安全技术措施等级顺序要求的具体原则,对措施进行等级排序。
4) hydrofoil model
水翼模型
5) flapping model
扑翼模型
1.
On the basis of former rigid wing model and consideration of the velocity change and the distortion of wing plane, a flapping model is developed.
在原有匀速刚性模型的基础上,提出考虑了扑翼扑动速率变化和形状变化的柔性扑翼模型,使之更接近鸟翼真实扑动情况。
6) rotor model
旋翼模型
1.
The hover test and wind tunnel forward flight test of pressure measurement rotor models was conducted using the method of squeezing the blade surface to form slots,then pasting the ultarminiature thin pressure transducers and covers sensors with paster.
采用"桨叶表面预先压槽,再粘贴片式压力传感器并粘胶带再开测量孔"的方法测量旋翼模型桨叶表面压力,在8m×6m风洞完成了地面悬停和风洞前飞试验,研究了桨叶表面压力测量技术和数据采集处理技术,获得了桨叶表面特征剖面的压力分布,建立了实用的旋翼模型桨叶表面压力测量试验技术。
2.
To meet the requirements of helicopter type-selection and dynamic characteristic principal research,CARDC Low Speed Institute developed Φ2m rotor model test stand.
为满足直升机选型试验及旋翼气动特性机理性研究的需要,中国气动研究与发展中心低速所研制了Ф2m旋翼模型试验台。
补充资料：鱼刺
1.鱼的细而尖的骨头。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条