1)  vertical axis
立轴
2)  spindle drill
立轴钻机
1.
The present status and prospect of mineral exploration drilling market in China were summarized,and also the advantages and disadvantages and the comprehensive efficiencies of the conventional spindle drills and the fully-hydraulic top-drive head drills were discussed.
概述了我国地质找矿钻探市场现状及前景,分析研究了地质取样钻探传统的立轴钻机及全液压动力头钻机的优缺点及综合效能,针对国家提出加强地质工作的形势及中国的实际状况,提出了完善和改进我国现有钻探设备、提高我国地质找矿取样钻探效率、降低能耗及成本的观点及建议。
2.
The paper introduces the improvement on chuck of spindle drill to realize the inner assembly fishing without re- gressing the drill.
介绍了通过对现有立轴钻机卡盘改进实现绳索取心钻进机上打捞内管总成、无让车加接钻杆的应用情况, 提出了利用现有立轴岩心钻机提高绳索取心钻探效率、减少复杂地层钻进施工孔内坍塌事概率、降低劳动强度及提高时间利用率的创新观点。
3)  steering vertical shaft
转向立轴
4)  vertical vortex
立轴旋涡
1.
Model investigation of vertical vortex at horizontal intake;
侧向水平进水孔口立轴旋涡的试验研究
2.
Model investigation and numerical simulation of vertical vortex;
立轴旋涡试验与数值模拟研究
3.
Experiment study of vertical vortex at hydraulic intakes;
进水口前立轴旋涡的试验研究
5)  vertical shaft
立轴式
1.
A vertical shaft thresher has been developed to meet the need for harvest mechanization in the hilling regions of South China where the double-cropping system (paddy and wheat) is practiced.
针对南方丘陵稻麦两熟地区分段收获机械化的需要，研制出立轴式脱粒机。
6)  erect swirl
立轴漩涡
1.
In a number of hydraulic model tests of the strip-shaped and restricted-orifice tailrace surge chamber,penetrating erect swirl all came forth without exception.
在多个长廊阻抗式尾水调压室水力学模型试验中均出现贯穿性立轴漩涡,运用三维计算流体力学方法建立了气液两相流VOF模型,分析立轴漩涡产生的原因。
参考词条
补充资料：立轴
立轴　　国画装裱中直幅的一种体式，亦称“挂轴”。立轴的当中为画心，四周镶边，边宽的尺寸依画幅的尺寸而定，以协调为主，一般的比例是：天头的空白比地头的空白长约五分之二，左右边宽各二寸左右。立轴是国画装裱的基本体式，其它许多装裱体式，如中堂、吊屏、横披、手卷、册页都是在它的基础上，或长、或短、或横、或直、或简、或繁衍变而成的。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。