2) blending procedure
共混工艺
1.
ABS/PBT blends compatibilized with styrene-maleic anhydride(SMA) was prepared in a corotating twin-screw extruder with different blending procedure.
以苯乙烯-马来酸酐共聚物(SMA)为增容剂,研究了共混工艺对ABS/PBT共混物聚集态结构和力学性能的影响。
2.
Acrylonitrile/butadiene/styrene copolymer(ABS)/nylon 6(PA6) blends compatibilized with styrene-maleic anhydride (SMAH) was prepared in a corotating twin-screw extruder with different blending procedure.
以(苯乙烯/马来酸酐)共聚物(SMAH)为增容剂,研究了共混工艺对(丙烯腈/丁二烯/苯乙烯)共聚物/尼龙6(ABS/PA6)共混物聚集态结构和力学性能的影响。
3.
PA6/ABS(acrylonitrile-butadiene-styrene) blends compatibilized with styrene-maleic anhydride (SMA) were prepared in a corotating twin-screw extruder with different blending procedures.
以苯乙烯-马来酸酐共聚物(SMA)为增容剂,研究了共混工艺对PA6/ABS共混物结构和力学性能的影响。
3) heating blend technology
热混工艺
4) mixing procedure
混炼工艺
1.
Study on mixing procedure of TPU/EVA blend;
TPU/EVA共混物混炼工艺的研究
2.
Effect of mixing procedure on properties of carbon black-reinforced TPI/SBR blend;
混炼工艺对炭黑补强TPI/SBR并用胶性能的影响
5) blending technology
共混工艺
1.
Influence of Blending Technology on Aggregation Structure and Property of ABS/PA6 Blend;
共混工艺对ABS／PA6共混物聚集态结构及性能的影响
2.
Effect of Blending Technology on Mechanical Properties of PP/PA6/Nano-meter SiO_2 Composite;
共混工艺对PP/PA6/纳米SiO_2复合材料力学性能的影响
3.
Influence of ingredient and blending technology on properties of HMWPVC/POM/NBR ternary blending elastomer;
共混工艺对HMWPVC/POM/NBR弹性体性能的影响
6) mixing process
混合工艺
1.
The mixing technical characteristics of the two rotor continuous mixer and the influence of the rotor structure and dimension, linear velocity at rotor wing tip and orifice setting on the mixing process were discussed.
讨论了双转子连续混炼机的混合工艺特点及转子结构尺寸、转子螺棱顶部线速度、物料卸料门开启度大小对混合过程的影响,提出以物料在混炼机中的轴向混合循环次数、转子螺棱顶部线速度为基本参数控制混炼机的混合过程。
补充资料：采用滑模工艺建造钢筋混凝土烟囱
采用滑模工艺建造钢筋混凝土烟囱
采用滑模工艺建造钢筋混凝土烟自
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条