1) common axis
公共轴线
1.
Through analyzing the unreasonable design in practical engineering,this paper expounds the points for attention when the mark datum is on anaxis or on a common axis.
对实际工程中存在的不合理的设计进行剖析,阐明了在轴线或公共轴线上标注基准时应注意的事项;并对实际零件进行具体分析,论述了如何根据零件的使用性能、工艺性能、检查的方便性来选择正确的标注形式。
2) concentric line
公共线，总线，同轴线
3) collinear axle
共线轴
5) common axis
公用轴线
6) Common bus
公共总线
1.
WT5”BZ]This paper discusses a kind of common bus multi microcomputer system that consists of 8096/8051 single chip microcomputer module、common shared memory and I/O、interface of bus and arbitrator.
:讨论了公共总线多单片机系统 ,该系统由 80 96 / 80 5 1单片机主模块、共享存储器、共享 I/ O、总线接口及仲裁器构成 。
2.
Described in this paper is a control scheme of adding PABX modules with the use of common bus, common memory and multimodules taking common bus polling in turn to get communication among PABX modules CPUs.
本文概述了一种利用公共总线，公共存储器，环路控制模块间轮循占用公共总线，进行多模块计算机间通讯的控制方案。
补充资料：DNA分子花窗(沿B―DNA轴线方向看)
[图]
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条