1) concentration line
公共线
2) common axis
公共轴线
1.
Through analyzing the unreasonable design in practical engineering,this paper expounds the points for attention when the mark datum is on anaxis or on a common axis.
对实际工程中存在的不合理的设计进行剖析,阐明了在轴线或公共轴线上标注基准时应注意的事项;并对实际零件进行具体分析,论述了如何根据零件的使用性能、工艺性能、检查的方便性来选择正确的标注形式。
3) Common bus
公共总线
1.
WT5”BZ]This paper discusses a kind of common bus multi microcomputer system that consists of 8096/8051 single chip microcomputer module、common shared memory and I/O、interface of bus and arbitrator.
:讨论了公共总线多单片机系统 ,该系统由 80 96 / 80 5 1单片机主模块、共享存储器、共享 I/ O、总线接口及仲裁器构成 。
2.
Described in this paper is a control scheme of adding PABX modules with the use of common bus, common memory and multimodules taking common bus polling in turn to get communication among PABX modules CPUs.
本文概述了一种利用公共总线，公共存储器，环路控制模块间轮循占用公共总线，进行多模块计算机间通讯的控制方案。
4) common wire
公共导线
5) common bus
公共母线
6) common winding
公共线圈
补充资料：DNA分子花窗(沿B―DNA轴线方向看)
[图]
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条