1) SiC-platelet
SiC板粒
1.
Effect of Al_2O_3 Addition on Mechanical Properties of SiC-platelet/Y-TZP Composites;
添加Al_2O_3对SiC板粒／Y－TZP复合材料力学性能的影响
2) SiC particles
SiC颗粒
1.
The surface treatment of oxidation, acid-washing and acid-washing after oxidation were carried out on SiC particles, then 6066 aluminum alloy reinforced by SiC particles was fabricated by powder metallurgy route.
分别对SiC颗粒进行高温氧化、酸洗和高温氧化后再酸洗等表面处理,采用粉末冶金工艺制备了SiC颗粒增强的6066Al基复合材料。
2.
The initial research on bearing steel composites reinforced with 4%SiC particles by electro-slag melting and casting method have made.
用电冶熔铸的方法制备 4%SiC颗粒增强轴承钢复合材料 ,对其组织性能进行探索。
3.
Aluminum matrix composites reinforced with different volume fraction of SiC particles were manufactured by semi-solid casting in this thesis.
本文采用半固态复合铸造法制备了SiC颗粒增强铝基复合材料，并对这一系列材料的微观组织、硬度及耐磨性能进行了研究与分析。
3) SiC Particle
SiC颗粒
1.
Effect of pre-heating processing of SiC particles on porosity of SiC/Al composites;
SiC颗粒加热预处理工艺对SiC/Al复合材料制备的影响
2.
Study on the separation of the paramorphic SiC whisker and SiC particle;
同质异形体SiC晶须与SiC颗粒的分离
3.
The influence of SiC particles on grain structure development during laser rapid solidification;
SiC颗粒对Al-Zn合金激光快凝晶粒组织的影响
4) SiC particle
SiC微粒
1.
The surface morphology and microstructure of the two kinds of brush plating coatings are observed with metalloscope, SEM and XRD, the effect of SiC particle on the surface morphology and microstructure of Ni-P alloy brush plating coatings is discussed.
通过金相显微镜、扫描电镜和X射线衍射能谱仪等观察和测试了两种刷镀层的表面形貌和结构,探讨了SiC微粒对Ni P合金刷镀层表面形貌和镀层结构的影响。
2.
A Ni-based composite coating containing micro-SiC particles is prepare d by pulse electrodeposition on 45# steel substrate.
采用脉冲电镀在 4 5 #钢表面制备含有SiC微粒的镍基复合镀层 ,研究了镀液中SiC的质量浓度、脉冲平均电流密度、pH值对Ni SiC复合镀层的影响规律。
3.
The results revealed that SiC particles surrounded by Ni-P were dispersed homogeneously in the coating and there was an electron transfer between SiC and Ni-P.
对化学镀Ni P SiC复合镀层的微观组织结构特征进行了研究 ,结果表明 ,SiC微粒弥散分布在复合镀层中 ,Ni P合金主要作为粘结金属包络着SiC微粒 ,两者之间存在电子转移 ,发生了界面反应 ,反应扩散层为 10 - 1nm级 ,界面结合紧密 ,无孔隙和裂纹等缺陷。
5) SiC particulates
SiC颗粒
1.
Copper matrix composites reinforced with SiC particulates were fabricated making use of powder metallurgy and hot extrusion processes.
结果表明,SiC颗粒作为增强相可以起到承载作用、减轻基体同偶件之间的粘着作用以及使基体产生塑性变形,从而显著改善复合材料的耐磨性能。
2.
The results show that the pretreatment of fibers hybridized withfine SiC particulates can improve not only the fiber distribution, but also the flexural property.
利用真空压力浸渗法制备了石墨纤维增强的铝基复合材料（Gr／ZL101A），研究了不同的纤维分布状态（SiC颗粒混杂纤维与未混杂的纤维）对复合材料显微组织及弯曲性能的影响。
6) SiC particle
SiC粒子
1.
The non-uniform distribution of the SiC particle volume fraction in the matrix and the aspect ratio are considered for the evaluation of the stress-strain relationship and the damage.
为了评价应力-应变关系及损伤的主要因素,考虑了基体中SiC粒子的体积率和径比的非均匀分布。
补充资料：牛柳粒炒杂菜粒
牛柳粒炒杂菜粒
原料：牛肉半斤、杂菜粒一包.
佐料：盐、糖、酱油、黑椒粉(可因个人口味增减)、油、蒜茸(同黑椒粉)、鸡粉。
过程：
1．将牛肉切粒，若不善刀工者可在市场买的时候就请人代劳。用酱油、油、糖、生粉捞一捞。
2．用少少的油热一下锅，爆香蒜茸；
3．将牛肉粒倒进锅里，中火翻炒一分钟，加入黑椒粉、鸡粉，看牛肉转了颜色就可以装出来，不然牛肉会炒老；
4．不用再加油了，倒入杂菜粒(事先要过水)，翻炒一分钟，加一点盐；
5．加入牛肉粒再翻炒1-2分钟；
6．大功告成，上盘。
温馨提示
杂菜粒在一些比较大型的超市里会有配好一包一包售卖的，可以挑选自己喜欢的口味，做菜前只需将其用开水泡一泡就可以了。油不用放得太多，只在开始放上两锅铲就够了，以健康为主。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。