1) pre-filling procedure
预充填过程
2) pre-filling process
预冷充填过程
3) filling stage
充填过程
1.
The influences of gas channel layout on the gas-assisted co-injection molding(GACIM) process are investigated by CAE technology based upon the governing equations of the filling stage of GACIM process.
基于气体辅助共注射成型充填过程的控制方程,采用CAE方法研究了气道布局对气体辅助共注射成型工艺的影响。
2.
Numerical simulation of the filling stage of thin cavity injection molding is carried out with viscoelastic fluid model to discover the effect of viscoelastic properties of polymer on the quality of injection molding parts.
为反映聚合物粘弹属性对注塑产品质量的影响,基于粘弹本构模型,对三维薄壁制件的注射成型充填过程进行了数值模拟研究。
4) Filling Process
充填过程
1.
Research on two-phase filling process of cryogenic propellant for a LOX/Kerosene LRE;
液氧煤油发动机低温组元两相充填过程研究
2.
This paper is aimed at the filling process of actual molds with curves and surfaces.
针对压铸、挤压等铸型型腔具有曲线、曲面这一情况，对具有任意曲线边界的型腔充填过程进行了研究。
3.
That means the fuel filling process is needed for the energy supply system which obtains the fuel by both squeezing and drawing.
首次依据液压流体力学和工程热力学的基本原理，对能供系统工作过程进行了深入地研究，建立了充填过程数学模型，并以某型热动力装置功率试验状态进行了计算。
5) Filling Process
填充过程
1.
Research on Flowchart Simulation of Filling Process of Plastic Melt in Injection Mould;
注塑模塑料熔体填充过程的流程图模拟研究
6) mold filling
充填过程
1.
With the thickness fraction of materials introduced,control volume method was used to tracking the moving interface during polymers mold filling.
基于Hele Shaw流动模型,推导出顺序共注射成型充填过程的数值模型;并引入厚度分数,采用控制体积法来实现运动界面的追踪。
补充资料：设备安装前的准备工作——设备的预装配与预调整
设备安装前的准备工作——设备的预装配与预调整 | ||
|
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条