说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 冷塑变渗氮
1)  cofd deformation plus nitriding
冷塑变渗氮
2)  deform-nitriding
形变渗氮
1.
The fractional dimension of impact fractured surfaces of 08Al steel after deform-nitriding were measured by vertical section method.
本文利用垂直截面法测量了08F钢经不同形变渗氮复合处理后冲击断裂表面的分形维数。
3)  micro-distortion nitriding
微变形渗氮
4)  cold plastic deformation
冷塑性变形
1.
The effect of cold plastic deformation on pack chrome-RE-boronizing of steel 45 was studied by OM,SEM and Micro-hardometer.
利用金相显微镜和扫描电镜观察及显微硬度测试,研究了冷塑性变形对45钢硼铬稀土共渗的影响。
2.
The boronizing speed increases obviously after cold plastic deformation (CPD)under two processes,and the depth of the layer increases with the increase .
结果表明,低温共渗层的组织比高温共渗层的致密,疏松、孔洞少;冷塑性变形在两种工艺条件下都明显促进了渗硼的进行,且都随着变形量的增加渗层深度增加;高温共渗得到FeB和Fe2B双相硼化物,低温共渗得到单一Fe2B相;冷塑性变形对渗层的硬度基本没有影响。
5)  amount of cold plastic formation
冷塑性变形量
1.
Under the condition of the laboratory, the relations of quenching, soaking time, interred time between quenching and aging, amount of cold plastic formation and artificial aging process with properties of alloy 2A12 sheet are studied.
在实验室条件下,研究了淬火加热温度、淬火加热保温时间、淬火后停放时间、冷塑性变形量和人工时效制度与2A12合金板材性能的关系,并确定了该合金的形变热处理制度。
6)  nitriding ['naitraidiŋ]
渗氮
1.
Liquid phase plasma electrolytic carburizing, nitriding,carbonitriding technique;
液相等离子体电解渗碳、渗氮及其碳氮共渗技术
2.
Optimum study on atmospheric pressure non-equilibrium plasma nitriding using dielectric barrier discharge;
常压介质阻挡放电非平衡等离子体渗氮工艺的优化
3.
Effect on substrate-film adherence of TiN film enhanced plasma nitriding;
等离子体渗氮与氮化钛膜沉积一体化工艺对膜基结合力的影响
补充资料:冷模塑泡沫塑料
分子式:
CAS号:

性质:采用模塑成型工艺、在室温下熟化生产的高回弹泡沫塑料

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条