1) cold craking tendency
冷裂倾向
2) cracking tendency
开裂倾向
1.
Study on high strength low auto-shrinkage concrete with composite aggregate III ——Predication of early age cracking tendency of high strength low auto-shrinkage concrete with composite aggregate;
高强低自收缩复合骨料混凝土早期开裂倾向的预估——高强低自收缩复合骨料混凝土的研究之三
2.
Effect of gear module on cracking tendency of laser-clad coating;
齿轮模数对激光熔覆层开裂倾向的影响
3.
Comparing with its time-dependent tensile strength the early age cracking tendency is reduced significantly by the composite aggregate in.
与混凝土的依时抗拉强度比较,复合骨料混凝土的早期开裂倾向显著降低。
3) hot tearing tendency
热裂倾向
1.
Research of hot tearing tendency of Al-4.5Cu alloy;
Al-4.5Cu合金热裂倾向的研究
2.
The effect of processing parameters on mechanical properties and hot tearing tendency of indirect squeeze casting Al-Cu based alloy has been studied in this paper,microstructure and properties of the alloy are analyzed.
研究了在间接挤压铸造条件下,工艺参数对铝铜合金力学性能及热裂倾向的影响,并分析了合金的组织和性能。
4) hot cracking tendency
热裂倾向
1.
A semi-quantitative method was proposed to evaluate hot cracking tendency.
本文提出了热裂倾向评定的半定量等级标准，并进行了不同成分Ａｌ－Ｃｕ合金定向凝固热裂试验。
2.
The experiment result proves good repeatability of hollow tube sample to evaluate hot cracking tendency.
采用空心圆管热裂试样对zc265定向凝固合金的热裂倾向性进行了研究,并结合扫描电镜等分析了热裂纹产生的机理。
3.
Mg can also significantly increase the hot cracking tendency of alloy.
0%Cu合金中加入合金元素Mg时,合金的热裂倾向增加。
5) Fracture tendency
断裂倾向
6) bursting tendency
裂解倾向
补充资料：冷裂
coldcracking：在冷态或近于冷态的金属或合金中发生的裂纹形成的过程。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条