1)  weak-acid leaching
弱酸浸出
2)  weak acid
弱酸
1.
Performance of weak acid coating on latex glove surface;
乳胶手套表面弱酸涂层的性能(英文)
2.
The Improvements of the Test on Determining weak acid lonizational Degree and lonizational constant;
弱酸电离度和电离常数测定实验的改进
3.
This paper proposes that weak acid is a coordination compound that regards hydrogen ion as “coordination body” and regards acid radical as central atom.
本文首次提出将弱酸看成是以氢离子为“配体”,以弱酸的酸根为中心“原子”所形成的“配合物”,通过计算该“配合物”的生成函数N并绘制PH-N图,用Bjerrum,N。
3)  weak acids
弱酸
1.
This paper gives a new titrimetric method which is a buffered titration to be ablc to titrate weak acids and bases with dissociation constants less than 10 -7 .
对于离解常数小于10-7的弱酸弱碱,给出一种新的滴定分析法缓冲滴定法。
4)  feeble-acid-ammonium
弱酸铵盐
1.
Study on natural rubber latex been conserved with feeble-acid-ammonium salt;
弱酸铵盐保存天然鲜胶乳的研究
5)  weak acidity
弱酸性
1.
The synthetic technology of urea-formaldehyde resin with weak acidity initial condition;
弱酸性条件起始合成脲醛树脂的工艺研究
2.
The possibility of the synthetic technology of urea-formaldehyde(UF) resins with low formaldehyde emission under weak acidity condition was discussed.
探讨了在弱酸性条件下合成低甲醛释放量的脲醛树脂工艺的可能性。
6)  weak acidic
弱酸性
1.
Ammonium-free weak acidic electroplating technology for Zn-Ni alloy was developed.
研究了一种无铵弱酸性锌镍合金电镀工艺,并深入探讨了镀液的成分及工艺条件对镀层含镍量的影响,得到了镀层为γ相Ni5Zn21与δ相Ni3Zn22、且含镍量为13%的全光亮锌镍合金镀层,确定了电镀工艺规范。
参考词条
补充资料:氨浸出


氨浸出
ammonia leaching

o「、J Inehu氨浸出(ammonia leaehing)J下J含氨的水溶液作为浸出剂的浸出方法。氨是·种配位体,能与某些金属离子形成配合物(络合物)进入溶液。浸出过程一般通入氧作为氧化剂,氧化被浸出固体物料中的有价组分。氨浸出可在常压或加压下进行。含自然铜、氧化铜或碳酸铜的矿石,可在常压下浸出;而含铜、镍、钻、锌等硫化物精矿,则采用加压氧氨浸出,浸出温度通常为358一373K,氧气压力为0.7一1.4MPa。浸出液经蒸馏除去的氨,可用水吸收后循环使用。氨浸出的优点是能处理含铁高和含碱性脉石的矿物原料,设备的防腐问题容易解决。由于氨具有挥发性,氨浸出需要在密闭反应器内进行。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。