1) fibre preform
纤维预制块
1.
The mechanical behaviour of Al_2O_3 short fibre preform in the process of squeeze casting was analyzed using pseeudo 3-D preform model.
采用准三维预制块模型对Ａｌ_２Ｏ_２短纤维预制块在挤压铸造过程中的受压力学行为进行了分析。
2) Fiber Perform
纤维预制体
1.
Research on Method and Influence of Permeability Measurement of Fiber Perform;
纤维预制体渗透率测定方法及影响因素的研究
2.
Research on Method and Influence of Permeability Measurement of Fiber Perform Transvers;
纤维预制体铺层法向渗透率测定方法及影响因素的研究
3) carbon fabric perform
碳纤维预制体
4) carbon short fiber preform
碳短纤维预制件
5) shot alumina fiber preform
短纤维预制件
6) 3-D carbon fiber perform
3D碳纤维预制体
1.
In order to introduce a mass of SiC fillers into 10mm thick 3-D carbon fiber perform,four slurry infiltration method were applied: vacuum infiltration,pressure infiltration,pressure filtration,and vacuum suction straining.
为了在厚度为10mm的3D碳纤维预制体中大量引入SiC微粉,在料浆不变的基础上采用真空浸渗法、加压浸渗法、加压过滤法、真空吸滤法等四种料浆浸渗法进行试验,并对引入微粉的量及其分布进行分析对比。
补充资料：碳(石墨)纤维增强体(见碳纤维、石墨纤维)
碳(石墨)纤维增强体(见碳纤维、石墨纤维)
earbon(graPhite)fibrereinforeements
，、、里z耽维增强体earbon(graphi现inforcements用于复合材料中承受负荷，田的磷纤始知五史纤俯亡e)fibre起增强作
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条