1) ABS/PVC blends
ABS/PVC共混物
1.
The mechanical and theological properties of ABS/PVC blends are studied and the effects of compatibilizer α-SAN on the mechanical properties of ABS/PVC alloy are also discussed.
本文研究了ABS/PVC共混物的物理力学性能和加工流动性,并讨论了相容剂α-SAN对ABS/PVC共混物力学性能的影响。
2) PVC/ABS blend
PVC/ABS共混物
1.
The effect of plasticizer dioctyl phthalate(DOP) on the mechanical properties and shore A handness of PVC (SG-3,SG-5) and PVC/ABS blend were stuided.
研究了增塑剂DOP对聚氯乙烯(商品牌号SG-3,SG-5)及PVC/ABS共混物力学和硬度等性质的影响及其机理。
5) CPVC/ABS blend
CPVC/ABS共混物
1.
Effect of ABS resin on mechanical property and processability of CPVC/ABS blend was studied and the following results were obtained.
研究了ABS树脂对CPVC/ABS共混物的力学性能和加工性能的影响。
6) ABS/PMMA blends
ABS/PMMA共混物
1.
It was very important to modify ABS resin and develop ABS/PMMA blends with high gloss applicable to RHCM technology.
根据MPI模型和现有的注塑设备,设计并制造配套模具;选用市面上销售的盘锦乙烯工业公司生产的牌号为CH510的ABS树脂与台湾奇美实业股份有限公司生产的牌号为CM207的PMMA树脂,在不添加任何助剂的情况下,采用熔融共混法,制备不同配比的ABS/PMMA共混物;以最佳注塑工艺参数为指导,将ABS/PMMA共混物注塑成标准拉伸样条、标准热变形样条和标准冲击样条。
补充资料：聚酰胺/玻璃纤维增强ABS(树脂)共混物
分子式：
CAS号：
性质：在PA/ABS混合物中加入玻璃纤维进一步增强，可以提高PA/ABS的拉伸强度、刚度、硬度和弹性模量，提高热变形温度，改善耐磨性能。但加工流动性有所下降。
CAS号：
性质：在PA/ABS混合物中加入玻璃纤维进一步增强，可以提高PA/ABS的拉伸强度、刚度、硬度和弹性模量，提高热变形温度，改善耐磨性能。但加工流动性有所下降。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条