1) near net-shapeforming
近尺寸成型
2) near-net-shape
近净尺寸成型
1.
Based on the review on development of Nd-Fe-B magnet,several hopeful development fields are forecast and discussed,which include HDDR anisotropic NdFeB,near-net-shape sintered NdFeB,new high temperature NdFeB and anisotropic nano-composite Nd2Fe14B/α-Fe magnets.
这包括氢处理(HDDR)各向异性粘结钕铁硼、烧结钕铁硼的近净尺寸成型、带(片)铸工艺、潜在的新型高工作温度钕铁硼和可能的各向异性纳米复合烧结钕铁硼磁体。
3) moulding dimension
成型尺寸
1.
Precision of the plastic production directly relies on the precise design and calculation of the moulding dimensions.
塑料模具成型尺寸的准确设计和计算,直接关系到塑料件的精度。
4) near net-shape
近净尺寸
5) size of finishing product
成品尺寸
1.
The main cause of size fluctuation of large gauge finishing products(Φ120~Φ155mm)is the wobbling of piece between K1 and K2 of high speed wire rod finishing millSo,the 6-h guide and guard was applied,and the percent of pass of size of finishing product to C level was great increased
分析了高线轧机精轧机组K1与K2之间的轧件抖动,是造成大规格线材(Φ12 0~Φ15 5mm)成品尺寸波动的主要原因。
6) forming dimension
成形尺寸
1.
The influence of pin material,pin forming dimension,die design,process control and production management on the solderability of aluminum electrolytic capacitor is analyzed.
分析了铝电解电容器引脚材质的选择、引脚成形尺寸、成形模的设计、工艺控制及生产管理等对产品可焊性的影响,提出了切实可行的对策,以满足欧盟禁用物质指令对电容器可焊性提出的要求。
补充资料:工程图标准尺寸及坐标尺寸
标准标注类型,是我们常用的标注类型。而坐标标注是便于数控加工采用的另一中标注形式。PRO/E可以将两种标注方式进行转换。
· 3.2 标准标注到坐标标注的转换
注意: 转化为坐标标注的尺寸必须是线性标注的,下列尺寸不能转化为坐标标注:
- 被显示成线性尺寸的直径
- 中心线尺寸
- 选择MODIFY DRAW > Dim Params > Dim Type > Ordinate Dim > Create Base.
- 选择作为参考基准线的尺寸
- 选择基准的引出线,该点为0点
- 选择 MOD DIM TYPE > Lin to Ord .
- 选择线性尺寸:注意:必须选择具有相同基准的尺寸
========>>>>
1. 选择 DIM PARAMS > Diam Dim Type .
2.点击Ord to Lin
3.选择尺寸即可
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条