1) saponification speed
皂化速率
1.
And influences some substances existed in solvent on saponification speed of CH 3COOC 2H 5 are given.
研究了溶剂的性质以及溶剂中存在某种物质时对乙酸乙酯皂化速率的影响。
2) SR saponification rate
皂化率
3) oxidation rate
氧化速率
1.
The results show that the temperature plays the most important role to oxidation rate of copper wires,but different copper wires have different sensitivity to temperature.
结果表明:温度的高低对铜线材的氧化速率起决定性作用,不同铜线材对温度的敏感程度不同。
2.
From the influence of drink osmolality,carbohydrate types and concentrations on water absorption and different types of carbohydrate on carbohydrate oxidation rate,the ways for sports drinks to effectively supplement water,carbohydrate and electrolyte during,after and before exercises in order to maintain body fluid balance,supply energy and enhance exercise capacity are summarized.
结合饮料渗透压、糖的种类和浓度对水分吸收以及不同类型糖对糖氧化速率的影响,综述了运动饮料如何有效的在运动中、运动后和运动前补充水分、糖和电解质等营养物质,以维持体液平衡、补充能量和提高运动能力。
3.
The relationships between oxidation rate and time and temperature were discussed.
研究了混合基体C／C复合材料在静态空气和流动氧气2种环境中的氧化动力学,探讨了氧化速率与时间、温度的关系,并对材料氧化后的显微形貌进行分析。
4) nitrification rate
硝化速率
1.
Numbers and nitrification rates of heterotrophic bacteria and nitrifiers in self-purification culture of Paralichthys olivaceus;
牙鲆自净式养殖槽中异养细菌和硝化细菌数量及硝化速率
2.
The nitrification rates,measured under different temperatures through nitrification experiments by embedded nitrobacteria granular reactor and biological contact oxidation reactor,both reach maximum nitrification rates of 40?mg N/(L·h) and 31?mg N/(L·h) respectively at 28℃.
通过包埋固定化硝化菌颗粒和生物接触氧化法在不同温度条件下的硝化反应速率测定试验,发现在28℃时两个反应器均达到最大硝化速率,分别为40 mgN/(L。
3.
The experiment,adopting CSTR(continuous stirred tank reactor),through measuring the nitrification and denitrification rate as well as the phosphorus' releasing and adsorbing rates at different temperatures and pH conditions,summarizes the effects of temperature and pH on the biochemical reaction rate of activated sludge.
试验表明,硝化和反硝化速率随温度的升高而加快。
5) curing rate
固化速率
1.
The influence of varieties and amount of photoinitiator,radiation distance,curing time,and structure of resins on UV curing rate is discussed.
将环氧大豆油与丙烯酸反应制备出环氧豆油丙烯酸酯预聚物,考察了光引发剂的种类、用量、辐射距离、时间及合成树脂的结构对光固化速率的影响,并利用红外光谱对树脂固化前后的结构进行了表征。
2.
It was proved by experiments that the fastest curing rate was reached for black UV-curable ink-jet ink with photointiator 2022.
选用7种光引发剂配制数码喷墨用黑色UV固化油墨,实验结果表明,使用光引发剂2022的固化 速率最快;当光引发剂与胺促进剂复配时,UV固化油墨的固化速率有较大提高。
6) acidogenesis rate
酸化速率
1.
The influence of pH value on anaerobic hydrolysis and acidogenesis rates of biodegradable organic waste.;
pH值对有机垃圾厌氧水解和酸化速率的影响
补充资料：阿莫法连续皂化
分子式：
CAS号：
性质：经油脂水解路线制皂基的方法。由油脂水解、脂肪酸蒸馏及中和三部分组成。原料油如牛油、椰子油不预先混合，而是分别进行水解和蒸馏，经脂肪酸混合后在阿尔法-拉伐尔皂化器中连续中和成皂基。
CAS号：
性质：经油脂水解路线制皂基的方法。由油脂水解、脂肪酸蒸馏及中和三部分组成。原料油如牛油、椰子油不预先混合，而是分别进行水解和蒸馏，经脂肪酸混合后在阿尔法-拉伐尔皂化器中连续中和成皂基。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条