1) particle size
乳胶粒粒径
1.
It was discovered that,with ratio of MMA getting large particle size wasgetting larger and Stabilities of polymerization was getting poorer; With ratio of MAA getting larger, Visosity was gettinglarger; high solid content emulsion of BA/MMA/MAA was mainly atactic copolymerized and was amorpous polymer.
发现：混合单体中MMA用量增加，乳胶粒粒径变大；聚会稳定性变差；MAA用量加大，乳液粘度变大；高固含量BA／MMA／MAA乳液聚合主要是无规聚合；共聚物聚集态为非晶态。
2) latex particle size
乳胶粒径
1.
The effects of amount and composition of composite emulsifiers and of redox initiators on latex particle size were discussed by orthogonal experiment and homogeneous design experiment respectively.
研究了醋酸乙烯酯 /丙烯酸丁酯 /丙烯酸三元共聚合乳液的合成工艺条件 ,应用正交实验和均匀实验设计得出了乳化剂用量及配比 ,氧化 -还原引发剂用量及配比对乳胶粒径的影响 ,乳化剂及体系 p H值对乳液稳定性的影响 ;采用间歇法聚合工艺 ,当乳化剂用量为 7。
3) small particle size latex
小粒径胶乳
1.
Polybutadiene latex(PBL) particles with diameter of about 100 nm were prepared through synthesis technology of small particle size latex,then part of large particle size were getted through agglomeration technology,and thus to gain bimodal distribution of PBL.
通过小粒径胶乳合成工艺制备粒径100 nm左右的聚丁二烯胶乳(PBL),然后通过附聚得到部分较大粒径PBL,从而获得具有双峰粒径分布的附聚胶乳,附聚胶乳接枝后再与(苯乙烯/丙烯腈)共聚物掺混造粒制得(丙烯腈/丁二烯/苯乙烯)共聚物(ABS)。
6) PSA-A latex
PSA-A乳胶粒
1.
In this paper,anionic PSA-A latex particles can be coated with hydrate CeO2 by aging the solution containing PSA-A,urea,and Ce(SO4)2.
以PSA-A乳胶粒为模板,通过硫酸高铈和尿素的水解反应得到PSA/水合CeO2的核/壳结构的复合微球,通过煅烧除去乳胶粒模板得到立方相CeO2空心微球。
补充资料：牛柳粒炒杂菜粒
牛柳粒炒杂菜粒
原料：牛肉半斤、杂菜粒一包.
佐料：盐、糖、酱油、黑椒粉(可因个人口味增减)、油、蒜茸(同黑椒粉)、鸡粉。
过程：
1．将牛肉切粒，若不善刀工者可在市场买的时候就请人代劳。用酱油、油、糖、生粉捞一捞。
2．用少少的油热一下锅，爆香蒜茸；
3．将牛肉粒倒进锅里，中火翻炒一分钟，加入黑椒粉、鸡粉，看牛肉转了颜色就可以装出来，不然牛肉会炒老；
4．不用再加油了，倒入杂菜粒(事先要过水)，翻炒一分钟，加一点盐；
5．加入牛肉粒再翻炒1-2分钟；
6．大功告成，上盘。
温馨提示
杂菜粒在一些比较大型的超市里会有配好一包一包售卖的，可以挑选自己喜欢的口味，做菜前只需将其用开水泡一泡就可以了。油不用放得太多，只在开始放上两锅铲就够了，以健康为主。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。