1) Gluebond strength
浸渍剥离
2) peel loss after HCl immersion
HCl浸渍后的剥离损失
1.
This paper describes the effect on adhesion between the orientation of Zn plating on the Cu foils and peel loss after HCl immersion, after the electro-galvanized Cu foils were exposed to the aging treatment atmosphere (313K, 90% RH, 168h).
概述了镀锌的铜箔暴露于老化处理氛围中(313K,90%RH,168h)以后,铜箔上镀锌层的取向和HCl浸渍后的剥离损失对附着性的影响。
3) delamination ratio after hot water-soaked
浸泡剥离率
4) immersion-precipitation phase inversion
浸渍沉淀相分离
1.
A novel kind of guided tissue regeneration (GTR) barrier membrane was fabricated using an immersion-precipitation phase inversion technique with the biodegradable material of chitosan.
以可降解壳聚糖为材料,运用浸渍沉淀相分离工艺制备了壳聚糖膜,用扫描电镜观察了膜的微观形态,并研究了聚合物溶液浓度、溶剂蒸发时间等工艺条件对膜孔隙率、溶胀性以及拉伸强度和断裂伸长率等性能的影响。
5) impregnation
[英][,impreg'neiʃən] [美][,ɪmprɛg'neʃən]
浸渍
1.
Studies on Dehydrogenation of 2-Butanol over Supported Copper Catalysts Prepared by Sol-Gel and Impregnation Methods;
溶胶-凝胶和浸渍法制备的铜催化剂在仲丁醇脱氢反应中的研究
2.
Impregnation and Molding Process of Long Fibre Reinforced Thermoplastic Composites;
长纤维增强热塑性复合材料的浸渍技术与成型工艺
6) dipping
[英][dip] [美][dɪp]
浸渍
1.
Fabrication of porous ceramics using polymeric sponge dipping method;
有机泡沫浸渍法制备多孔陶瓷
2.
Study on dipping modification technology of fast-growing China fir of Hunan Province;
湖南速生材杉木浸渍改性工艺研究
3.
On Dipping Composite Material of Nanometer SiO_2 and PF Polycondensate;
浸渍用纳米SiO_2与PF预聚物复合材料合成实验
补充资料：180°剥离
分子式：
CAS号：
性质：剥离角为180°的剥离是受力方向与剥离方向相平行，剥离角成180°的剥离方法，其试样由刚性材料及柔性材料构成。强度用kN/m表示。
CAS号：
性质：剥离角为180°的剥离是受力方向与剥离方向相平行，剥离角成180°的剥离方法，其试样由刚性材料及柔性材料构成。强度用kN/m表示。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条