Allowable rolling pressure for small-flexibility slab edging

There occurs heavy fish tail and width shortage around the head and tail ends of the slab resulted from unsteady state deformation during slab edging with flat cylindrical roll in roughing stands of hot strip mill.

This paper introduces horizontal shaft of vertical mill is changed into statically indeterminate beam supported by three points used of virtual constraint in the reforming process of RE1 vertical mill transmission device of 500mm hot strip mill production line in Laiwu iron and steel general works,thus the strength,rigidity and transmission stability of this mill are increased.

According to the testing parameters of a 4200 vertical mill and by using the numerical calculation combined with theoretical analysis,this paper proposes a nonlinear vibration model with four degrees of freedom for the main transmission system of the vertical medium plate mill.

Based on physical simulation of edge rolling process in Trimming-Free Plate rolling method,the effection of V rolling and chamfer rolling on the plate profile is analyzed.

Based on physical simulation of edge rolling process,the article analyzed the effection of V rolling and chamfer rolling on the plate profile.

Analysis on reason of roll vertical rolling mill moderating machine spiral bevel wheel's broken teeth;

In addition, the difficulties to bite during initial stage of rolling in FEM and to control the deformation due to vertical rolling were solved too.

The article describes the function, composition and operational concept of edger mills.

The development of heavy plate mill and the common characteristics of the mill revamping were summarized, and the production technologies, such as control links of TMCP, appliction of edger mill and the processing of Steckel mill for plate were introduced.

The head and the tail of the slab formed instability parts due to haven\'t backward stress during the Edger mill rolling.