1) Mapping
面电位/电流分布
2) sheet resistance
面电阻
1.
Surface morphology, optical transmittance and sheet resistance were examined and characterized.
X射线衍射仪、扫描电镜、紫外可见分光光度计与四探针仪分别用于表征样品的晶体结构、表面形貌、透光率与面电阻。
2.
The optical transmittance and the sheet resistance of Cu films with different thickness were measured.
在室温条件下,用直流磁控溅射Cu靶制备出了不同厚度的Cu膜,测量了Cu膜的光学透过率和面电阻,分析了光电性质薄膜厚度的变化情况。
3) Surface Resistance
表面电阻
1.
Strain effect on microwave surface resistance of YBa_2Cu_3O_(7-δ)/LaAlO_3 and Tl_2Ba_2CaCu_2O_8/LaAlO_3 high temperature superconducting thin films;
YBa_2Cu_3O_(7-δ)/LaAlO_3和Tl_2Ba_2CaCu_2O_8/LaAlO_3高温超导薄膜内的应变对其微波表面电阻影响的研究
2.
The surface resistance Rs was measured by the four-probe method described in ASTM F 390.
分别用四探针法(ASTM F390)和双轴传输线法(ASTM D 4935-99)测量导电涤纶织物的表面电阻和电磁屏蔽效能。
3.
The results showed that the material with 5% content of carbon black could meet the requirement of the performance of motor blower fan material as the surface resistance reaching 1×108Ω.
结果表明,炭黑的质量分数为5%时,材料表面电阻率为108Ω数量级,力学性能优良,达到电机用塑料风叶材料的指标要求,并可应用于其它对抗静电性能要求较高的场合,用于制造某些结构件。
4) surface potential
表面电势
1.
The results show that the magnetite particle's surface potential can increase by adsorbing the polyacrylic,electricity repulsion between the particle hinders the reuniting of the magnetized particle,the anti.
结果表明,磁性颗粒对聚丙烯酸分子的吸附,增加了其表面电势,颗粒之间的静电斥力阻碍了团聚的发生,提高了体系的抗团聚、抗沉降稳定性。
2.
Besides,their surface potential was also evaluated with the electric force .
利用射频溅射法制备了GeSb2Te4薄膜并对其进行热处理,分析热处理前后样品的结晶情况,用纳米硬度计测定硬度,利用静电力显微镜表征样品的表面电势,采用原子力显微镜观察薄膜表面形貌,利用侧向力显微镜对比考察了在考虑相对湿度的情况下,热处理前后GeSb2Te4薄膜的粘附力和摩擦性能。
3.
Objective:To investigate the effect of dry heat antisepsis on charge storage stability of porous polytetrafluoroethylene(PTFE) films by measuring the isothermal surface potential(V S) decay,open-circuit thermally stimulated discharge(TSD), and piezoelectric d 33 coefficient.
目的:通过对表面电势VS 衰减和开路热刺激放电(open circuit thermally stimulated discharge ,TSD)电流以及准静态压电d33系数测量,研究干热消毒对聚四氟乙烯(PTFE)多孔膜电荷储存稳定性的影响。
5) surface charge
表面电荷
1.
Effects of pretreatment of chrysotile by three compounds on the crystal lattice structure and the surface charge of chrysotile;
三种化合物浸泡处理对石棉晶格结构和表面电荷的影响
2.
Effect of electret on cell growth and surface charge in fibroblast cells;
驻极体对成纤维细胞生长和表面电荷的影响(英文)
3.
Experimental study on surface charge properties of sediment particles and their effect on dry-bulk density;
泥沙颗粒表面电荷特性及其对干容重影响试验研究
6) Surface resistivity
表面电阻
1.
Antistatic properties of carbon black (CB) filled plasticized poly(vinyl chloride) (PVC) were studied using surface resistivity tester and SEM.
采用表面电阻测试和扫描电镜 ,分析研究了软质聚氯乙烯 (PVC)树脂与炭黑 (CB)复合体系的抗静电性与炭黑含量、分布形态、PVC树脂型号及混炼塑化工艺之间的关系。
2.
When nonionic electrostatic resistant is mixed with assistant electrostatic resistant,the composite's surface resistivity will be reduced to 3×10 8Ω or below.
实验结果表明 ,八溴联苯醚与 Sb2 O3 互配体系的氧指数可达 2 7以上 ;非离子型抗静电剂配以辅助抗静电剂 ,可使材料的表面电阻降至 3× 1 0 8Ω 以
参考词条
补充资料：电位降法测电偶电流
分子式：
CAS号：
性质：一种测定金属电偶腐蚀的简易方法。在被测的电偶对之间接一个已知的低阻值电阻，电偶电流流过时测定电阻两端的电压降，即可算出电偶电流，分析电偶腐蚀的行为。优点：设备简单易得；缺点：由于有一个电压降，故测出的电偶电流总是比电偶对完全短接时的实际电偶电流小。
CAS号：
性质：一种测定金属电偶腐蚀的简易方法。在被测的电偶对之间接一个已知的低阻值电阻，电偶电流流过时测定电阻两端的电压降，即可算出电偶电流，分析电偶腐蚀的行为。优点：设备简单易得；缺点：由于有一个电压降，故测出的电偶电流总是比电偶对完全短接时的实际电偶电流小。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。