1) thermal compressive stress
热压应力
1.
It is thought that the transient thermal compressive stress caused by high--rate heating is an important factor causin.
快速温升引起的瞬时热压应力可能是造成裂纹愈合的重要因素之一。
2) Thermal soft reduction
热应力压下
4) residual hot-pressing stress
热压残余热应力
5) thermo molecular effect of pressure
热分子压力效应
1.
The conclusion has been made that there is a cross transport phenomena in which a mass flux and a thermo molecular effect of pressure which produce a heat flux are produced by the gradient of the moisture and that of the temperature in wood.
本文应用不可逆过程热力学研究木材干燥过程中的热质迁移现象，从中得到结论：木材中的湿度梯度和温度梯度在引起物质流的同时、产生热分子压力效应亦可引起热流的交叉作用。
6) hot pressing pressure
热压压力
1.
The results show that,with the increase of hot pressing pressure,the open porosity decreases,relative density and bending strength increase.
研究了真空热压工艺、烧结助剂对碳化硼陶瓷性能及断口的影响,结果表明,以活性炭和碳化硅为烧结助剂的碳化硼陶瓷随热压压力增加,开口孔隙度减小,相对密度和抗弯强度增加。
补充资料：轧辊残余应力(见轧辊应力)
轧辊残余应力(见轧辊应力)
residual stresses in roll
zhagun eanyu yingli轧辊残余应力(residual stresses in roll)见礼辐应力。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条