1) spindle power
主轴功率
2) spindle motor power
主轴电机功率
1.
Based on the variation patterns of the spindle motor power signals during the milling cutter's progressive wear out, the time domain characteristics of the mathematical model between A VB and the spindle motor power are analyzed.
根据立铣刀刀齿渐进磨损过程中主轴电机功率信号的变化特点 ,分析了主轴电机功率与刀齿后刀面磨损带面积 (AVB)间模型的时域统计特性 ,提取了反映刀具磨损状态的时域统计特征参数。
3) power amplifier/active magnetic bearing
功率放大器/主动磁轴承
4) shaft power
轴功率
1.
Decreasing fluctuation of shaft power,assuring polypropylene device running steady;
减少轴功率波动 确保聚丙烯装置安全平稳运行
2.
Calculation of stirrer shaft power of a WPA reactor;
湿法磷酸萃取槽搅拌桨轴功率的计算方法
3.
Achievement of the dynamic measurement system of marine engme s shaft power;
船舶柴油机轴功率动态测量系统的实现
5) axle power
轴功率
1.
Critical suspending rotation speed for mixing is 314 r/min,and axle power is 156W with direct count method;In fact, design turn speed is 315 r/min, axle power is 2.
用直接计算法确定悬浮临界搅拌转速为 314r/min ,轴功率为 156W ;实际设计转速 315r/min ,轴功率 2 2kW。
2.
If a pump is powered by an electric motor, the axle power cannot be determined because of having a rotary joint between pump.
电机拖动泵类负载时,由于泵与电机对轴联接,因此泵的轴功率也不能确定,电机和泵的效率也不能单独计算。
3.
This problem can be solved easily by measuring the axle power of the main engine.
这个问题通过对主机轴功率的测试,容易得到解决。
补充资料：惯量主轴
见惯量张量。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条