1)  cut-edged V-belts
切边V带
2)  neoprene Edge-cut V-belt
氯丁橡胶切边V带
3)  cutting
切边
1.
Combined practice, the technology difficulties of sheet forgings with inner hole were introduced, for which the optimized design of dies for punching and cutting for top-plate forging was put forward.
结合实际,介绍了带内孔的薄板锻件的工艺难点,并就此工艺难点的解决介绍了锻件切边、冲孔模具的优化设计。
2.
The paper analysed reasons of deformation caused when cutting on H-shaped section of connecting rods, axial bend of shaft forgings and plane deformation of sheet gears;and gave corresponding improvement methods of dies.
分析了汽车发动机连杆锻件工字形截面在切边过程的“八字”变形、直轴类锻件切边时轴线弯曲及薄齿轮类锻件冲切时平面变形产生的原因,提出了相应的模具改进措施。
4)  trimming
切边
1.
The warp flash was produced and some of them were remained after trimming.
在16 t热模锻锤上锻造一批(150件)直径为Ф550 mm的行车轮时,有近3/4的锻件沿切边带出现开口分模面裂纹,并产生飞边残留及翘曲不平的叠饼状飞边。
2.
Analyzed the pressing process of the shell part, introduced the structure design points of drawing-trimming die.
对壳体的冲压工艺进行了分析,介绍了拉伸、切边模具结构设计的要点。
3.
Introduced the characteristics of the gear box case, and determinded the reasonable forming process, designed the drawing die, the trimming die, the piercing die and the flanging die.
介绍了变速箱壳体零件的工艺特点,确定了合理的工艺方案,设计了拉伸模、切边模、冲孔模、翻孔模,经生产验证,模具结构合理,生产的零件完全满足要求。
5)  trimming die
切边冲槽
6)  trimming and piercing
切边冲孔
1.
The friction press is a typical forging and pressing equipment,which is mainly used for forging production and seldom for trimming and piercing work.
摩擦螺旋压力机是一种典型的锻压设备,主要用于锻造生产,但在实际生产中,也会在摩擦螺旋压力机上进行切边冲孔。
参考词条
补充资料：波状(软边)挡边带式输送机
分子式：
CAS号：

性质：带式输送机的一种。在乎输送带的两侧加上有波纹形的软边，中间用隔板隔起来使其呈框形。可使其提升角度几乎不受限制，可达90°角。在提升角度大，运输场地受限制的情况下，采用此种带式输送机有显著的优越性。由于输送带上装有波形软边和隔板，物料装载厚度可以增高。输送带的清扫比较困难，维修比较复杂，不适用于有黏性的细粉物料。

说明：补充资料仅用于学习参考，请勿用于其它任何用途。