1) filled degree
进料度
1.
This paper introduces four kinds of method for increasing devolatilizing efficiency in cold feeding vented extruders These methods are:(1)reducing the filled degree of rubber compounds in the vented section of screw;(2)increasing the mean residence time in the vented zone;(3)enhancing the effect of renewing the evaporating surface;and (4)improving the ingredients and operating variable
介绍了 4种提高橡胶冷喂料排气挤出机除气效率的途径 :减少胶料在螺杆排气段中的进料度 ,增加胶料在排气段中的平均停留时间 ,增强胶料“自由”表面积的更新作用 ,改进配方设计和操作工艺条件等。
2) feed temperature
进料温度
1.
The effects of the feed composition and the feed temperature on the energy-saving efficiency of the backward-feed two-effect distillation are researched in ethanol-water system by process simulation.
以乙醇-水为物系,通过模拟计算,研究进料组成和进料温度对三种逆流双效精馏节能效果的影响。
2.
As the forward-feed,backward-feed,dual-feed two-effect distillation are not better used at the conditions of the feed temperature being higher than the bubble point temperature,we chose new type distillation flow-two-effects system with vapor feed to reboiler.
由于常见的双效精馏、顺流双效精馏、逆流双效精馏、平流双效精馏在泡点以上温度进料时,节能效果不是很理想,针对泡点以上温度进料,我们研究了新型节能流程——气体进料作再沸器热源双效精馏流程,以乙醇-水为实验物系,通过模拟计算,考察进料组成和进料温度对其节能率的影响。
3) input concentration
进料浓度
1.
Based in this equipment research,there are three main factors which influence the effect of system,including input concentration,daily input quantity and the quantity of sludge reflux.
针对牛粪的厌氧发酵设计了一套工业化试验装置,该装置是由降流式厌氧滤器(AF)和升流式厌氧污泥床(UASB)有机结合的新型动态序批式厌氧发酵系统,在此装置上对影响系统效果的进料浓度、日进料量和污泥回流量3个主要参数安排了二次正交回归试验研究,以产气量和COD去除率为目标函数进行了分析,结果表明,系统整体产气效率较高,处理牛粪的产气率最高可达2。
4) inlet particle granularity
进料粒度
5) rate of feeding
给进速度;进料速度
6) rate of feeding
喂料速度，进料速度
补充资料：料度
1.估计;忖度。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条