1)  urea process
尿素生产流程
2)  urea
尿素
1.
Study on the rheological behavior of cellulose/NaOH-urea-thiourea solution system;
纤维素/NaOH-尿素-硫脲溶液体系流变性能的研究
2.
Primary investigation of the low temperature dyeing process of wool based on urea;
以尿素为基础的羊毛低温染色工艺初探
3.
Study on spinnability of urea-solubilized cellulose carbamate;
尿素增溶纤维素氨基甲酸酯的可纺性研究
3)  carbamide
尿素
1.
Research of the Performance of Carbamide and Starch Size Mixture;
尿素与淀粉混合浆液的性能研究
2.
A Chemical Fertilizer with Biodegradation Polyurethane Integument Carbamide;
生物降解聚氨酯包膜尿素化肥的研究
3.
Open cell aluminum foams were prepared by traditional powder metallurgy process,with spherical carbamide particles as the space-holder.
以球形尿素颗粒为造孔剂,采用传统的粉末冶金工艺制备开孔泡沫铝并研究了其性能。
4)  NaOH/urea aqueous solution
NaOH/尿素
5)  urea adduction fractionation
尿素包合
1.
Decreasing the erucic acid content in Descurainia Sophia seed oil by freezing crystallization and urea adduction fractionation;
冷冻结晶法和尿素包合法降低播娘蒿籽油中芥酸的研究
2.
Purification of oleic acid from oil-tea camellia seed oil by urea adduction fractionation;
尿素包合法提纯油茶籽油中油酸的工艺研究
3.
Enrichment of linoleic acid from sunflower oil with improved urea adduction fractionation;
改进的尿素包合法富集葵花籽油中亚油酸的研究
6)  urea dewaxing
尿素脱蜡
1.
Comparison on urea dewaxing among straight-run diesel distillates of three crude oils;
三种原油的直馏柴油馏分油尿素脱蜡的比较
2.
New Energy Conservation Measures of the Urea Dewaxing Unit;
尿素脱蜡装置节能新举措
3.
The feasibility of usillg solvent dewaxing - urea dewaxing to produce low - pour- point lubricating oils was studied, the influences of two kinds of dewaxing methods on tile low temperature properties oflubricating oils were also analysed.
研究利用溶剂脱蜡一尿素脱蜡组合工艺生产低凝润滑油的可行性,并研究了不同脱蜡方法对润滑油低温性能的影响,研究表明,采用溶剂脱蜡-尿素脱蜡组合工艺生产低凝润滑油是可行的,尿素脱蜡所脱蜡对润滑油低温性能的影响程度要比溶剂脱蜡的大,相同脱错量时;尿素脱蜡油的低温性能要远比溶剂脱蜡油好;达到相同的凝点时,原东脱蜡油的收率要高于溶剂脱蜡油。
参考词条
补充资料:选矿生产线生产流程

选矿生产线具体生产流程如下:


   开采的矿石先由颚式破碎机进行初步破碎,在破碎至合理细度后经由提升机、给矿机均匀送入球磨机,由球磨机对矿石进行粉碎、研磨。经过球磨机研磨的矿石细料进入下一道工序:分级。


    螺旋分级机借助固体颗粒的比重不同而在液体中沉淀的速度不同的原理,对矿石混合物进行洗净和分级。经过洗净和分级的矿物混合料在经过磁选机时,由于各种矿物的比磁化系数不同,经由磁力和机械力将混合料中的磁性物质分离开来。 经过磁选机初步分离后的矿物颗粒在被送入浮选机,根据不同的矿物特性加入不同的药物,使得 所要的矿物质与其他物质分离开。在所要的矿物质被分离出来后,因其含有大量水分,须经浓缩机的初步浓缩,再经烘干机烘干,即可得到干燥的矿物质.

说明:补充资料仅用于学习参考,请勿用于其它任何用途。