1) continuous finishing line
连续精整线
1.
Introduction of continuous finishing line of Huchang Special Steel Co.,Ltd;
沪昌特钢连续精整线介绍
3) Dressing continuously in line
在线连续修整
4) CCR
连续重整
1.
IMPACT OF PROCESSING HIGH RATIO HYDROTREATED COKER NAPHTHA IN CCR UNIT;
掺炼高比例加氢后焦化汽油对连续重整装置的影响
2.
APPLICATION OF ADVANCED PROCESS CONTROL IN CCR UNIT;
先进过程控制在连续重整装置中的应用
3.
Application of APC on CCR and Aromatic Extraction United Unit;
先进控制在某连续重整-芳烃抽提联合装置中的应用
5) Continuous Catalytic Reforming
连续重整
1.
The text analyses the energy consumption of Qilu 600 kt/a Continuous Catalytic Reforming Unit,finds out the reasons of higher energy consumption and presents modification measures,obtaining good results and providing a method and clue of thoughts for energy saving and consumption decreasing of the unit of the same kind.
对600 kt/a连续重整装置能耗进行分析,找出能耗偏高的原因。
2.
0 Mt/a continuous catalytic reforming unit of Huizhou refinery,and the content of chlorine in the regeneration gas is 0.
0 Mt/a连续重整装置的催化剂再生气排放量为1。
3.
It is concluded that the continuous catalytic reforming process is still the most competitive process in petroleum refining industry.
指出目前连续重整为最有竞争力的工艺,大力发展芳烃等石油化工行业,加快连续重整生产工艺的国产化,打破长期以来国外公司对连续重整技术的垄断,有利于我国催化重整的可持续发展。
6) continuous reforming
连续重整
1.
Simulation of continuous reforming recontacting process;
连续重整再接触工艺过程模拟
2.
Commercial trial production of RC011 continuous reforming catalyst;
RC011连续重整催化剂的工业试生产
3.
Aiming at energy consumption of UOP second generation continuous reforming unit in Refinery of Beijing Yanshan Petrochemical Co.
针对中国石油化工股份有限公司北京燕山分公司炼油厂UOP第二代连续重整装置运行能耗状况, 通过采取适当提高反应压力,优化再接触操作条件,提高单台氢气增压机输送量等措施,达到了节约电耗的目的。
补充资料：钢锭精整
钢锭精整
ingot finish
gangding Jingzheng钢锭精整(i ngot finish)依据相应的技术条件，检查并清除钢锭表面缺陷并对钢锭质量加以判定的作业。精整方法有车床剥皮、砂轮修磨、风铲铲削及火焰清理等。对优质钢和合金钢，最普遍采用的是砂轮修磨。钢锭表面裂纹、重接、夹渣、结疤、表面气泡及深度大于4mm的麻点等缺陷，必须清除干净。清理处的凹坑应圆滑无棱角，且保证凹坑的深:宽:长达到1:4:6。高合金钢和某些裂纹敏感的钢种，钢锭修磨时应防止在一处长时间研磨或用力过大，以避免产生研磨裂纹。某些铁素体钢，如iCrx7，ooCrlsMoZ等要求在钢锭保持一定温度时精整，否则也会产生研磨裂纹，钢锭表面缺陷严重、清理深度过大时，钢锭应判废或判切去一部分。一般规定，7。。kg以下钢锭清理深度超过25mm者、大钢锭清理深度超过35mm者以及短锭、未达到冒口规定浇高的镇静钢钢锭、严重冒涨或下陷的沸腾钢钢钦均判废。带有严重的纵、横裂纹和重接的钢锭，可不经清理直接判废。精整合格后的钢锭方可检尺、检斤入库。 (艾慰心姜永林)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条