1) axial thrust
轴向推力
1.
Influence of friction coefficient on vibration characteristic of rub-impact rotor with axial thrust;
摩擦系数对轴向推力作用下碰摩转子振动特性的影响
2.
The paper in addition reports on systematic studies of the axial thrust calculation of turbine stages and the derivation of a new formula, accompanied by a detailed calculation of typical turbine stage.
对汽轮机级轴向推力计算进行了系统的研究并推导出新的公式,针对典型机组的级进行了详细计算。
3.
This paper presents a new method for measuring and testing of axial thrust for vertical canned motor pumps.
介绍测试立式屏蔽电泵轴向推力的一种新方法，其测试精度较高，并经过了实际产品验证，对实际操作具有指导意义。
2) axial force
轴向推力
1.
Taking the air conditioning water system of a high-rise building as an example, analyses the axial force resulting from ripple compensators on main vertical pipes and its characteristics during operation and pressure test.
以一高层建筑空调水系统为例,分析了水系统总立管上波纹补偿器在运行和水压试验状况下所产生的轴向推力及其特点,提出减小轴向推力的措施;并分析了水泵进出口管道上橡胶柔性软接头的安装位置对管道和水泵的影响,认为橡胶柔性软接头安装在水泵进出口横管上比安装在立管上好。
2.
The axial force and power consumption are important factors of affecting reliability of twin screw pulping ex-truder,at present there are no theory calculation methods about them.
轴向推力和功耗是影响双螺杆磨浆机可靠性的重要因素,目前尚无理论计算方法。
3) end thrust
轴向推力
1.
Then, the new thermal performance calculating methods and expression are used to calculate the degree of reaction of the last stage and the whole end thrust of CC12 type steam turbine heat supplying with low vacuum.
然后,利用改进的变工况热力计算方法及反动度解析式对CC12汽轮机低真空供热后的最末级反动度及整个汽轮机轴向推力进行了计算。
4) thrust force
推力，轴向力
5) axial hydraulic thrust
轴向水推力
1.
Research on axial hydraulic thrust of francis pump-turbine′s runner;
混流可逆式转轮轴向水推力研究
6) axial thrust
轴向水推力
1.
Prototype test of axial thrust for No. 3 unit of Three Gorges Left Bank Hydropower Station;
三峡左岸3号机组轴向水推力真机试验研究
2.
Calculation and analysis of axial thrust acting on turning wheel of flow-mixing reversible hydraulic turbines;
混流可逆式水轮机转轮轴向水推力计算分析
3.
Calculation of axial thrust during transients in a Kaplan turbine;
Kaplan机组过渡过程轴向水推力计算
补充资料：单轴各向异性
单轴各向异性是磁晶各向异性的最简单形式，即自发磁化的稳定方向（或易磁化方向）平行于一特殊晶轴。如六方晶系钴的自发磁化方向平行于 C轴(见晶体结构)，这就表现出强的单轴各向异性。磁性材料的单轴各向异性值一般都低于其磁晶各向异性值，为103erg/cm3量级。磁性材料经磁场热处理或强的冷加工而产生的感生各向异性，都属于单轴各向异性。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条