1) cold
[英][kəʊld] [美][kold]
冷态
1.
0D(D=183 mm),the fluidization velocities are determined in cold bubbling fluidized bed.
0D(D=183 mm,D为有机玻璃管内径)的冷态条件下木屑的流化速度变化情况。
2.
This paper gives a brief introduction of the process of cold commissioning on 135 MW CFB in Xinxiang Thermal Power Plant such as calibration of air meter, measuring of bed resistance, testing of primary air evenness, measuring of minimum fluidized air, testing of slag-colder and slag transport system and also presents a program for U-valve testing.
新乡火电厂135MWCFB锅炉冷态调试过程如风量标定、布风板阻力特性测定、布风均匀性检查、冷态临界流化风量测定、冷渣器及输渣系统试验等,此外还提供了回料阀试验方案供参考。
3.
PM4 CFBB were investigated on a self-made cold CFB experimental set to master the introduced-technology.
在自行研制的循环流化床冷态试验台上对哈锅引进 4 40t/hCFB锅炉关键部件特性及炉内气固流动特性进行了试验研究 ,测定了大直径钟罩式风帽及布风板的阻力特性 ,发现了安装方向对风帽的磨损规律 ,对分叉管U型回料阀和旋风分离器进行了模拟试验 ,对双炉膛结构对流动的影响进行了观察 ,认识了哈锅CFB锅炉的多方面特性。
2) cold state
冷态
1.
Based on the principle of NO X reduction using gas reburning in coal fired boiler, the velocity,temperature and concentration fields of jet are analyzed for single circular cross section nozzle on the condition of cold state by means of the self moulding theory of jet.
以喷气再燃技术降低燃煤锅炉 NOX排放的研究为背景 ,利用射流的自模性理论 ,在冷态下以圆断面射流为例 ,分析了单喷管喷气射流的速度场、温度场和浓度场 ,讨论了影响喷气射流与烟气主流混合的有关因素。
3) cold strength
冷态强度
1.
In this study,the effects of hot briquetting process parameters on cold strength of the CCB,and the mechanism of the CCB high strength are investigated and discussed.
本研究重点考察了煤种及热压工艺参数对热压含碳球团冷态强度的影响,并探讨了热压含碳球团获得高强度的机理。
2.
The effects of coal from different mines and hot briquetting process parameters on the cold strength of CCB were investigated,as well as the mechanism of acquiring high strength of CCB.
重点考察了煤种及热压工艺参数对热压含碳球团冷态强度的影响,并探讨了热压含碳球团获得高强度的机理。
4) cold state
冷状态
1.
The causes of long start-up time of the air separators under cold state were analyzed and several methods to shorten the start-up time were put forward.
介绍了本钢氧气厂引进林德产的两台35000 m3/h制氧机的流程特点,分析了目前冷状态下启动时间长的种种原因,提出了缩短启动时间的几种方法。
2.
A model to express startup behavior of batch columns starting from an empty cold state is proposed to handle this issue.
间歇精馏过程的一个特点就是精馏塔频繁地从冷状态启动 ,初始状态会因再沸器中每次料液的量、组成、组分的变化而不同 ,这给伪热初始状态的计算带来很多困难 。
5) dynamic secondary cooling
动态二冷
1.
Research on dynamic secondary cooling control model for slab continuous casting machine with high casting speed;
高拉速板坯连铸机动态二冷控制模型研究
2.
Modelling and Control of Dynamic Secondary Cooling and Soft Reduction in Continuous Slab Casting
板坯连铸动态二冷与轻压下建模及控制的研究
3.
The dynamic secondary cooling and dynamic soft reduction control model designed and developed by USTB and Baotou Steel has been put into operation on this bloom caster.
北京科技大学与包钢合作设计与开发了拥有自主知识产权的大方坯动态二冷与动态轻压下二级控制模型并已在该铸机上成功上线应用,模型能够在非稳态的浇注条件下实施有效的大方坯动态轻压下和动态二冷配水实时控制。
6) supercooled liquid
过冷液态
1.
According to the result, the joint which will be avoided crystallizing should be in supercooled liquid with good thermal stabilization, superplasticity and viscous flow, at the same time, the temperature of the joint should always be under the crystallization temperature of the BMG.
5Ni15的连接;根据试验结果,探讨了焊接接头保持非晶的条件,即:被焊块体非晶合金处于过冷液态,且该过冷液体具有较好的热稳定性、超塑性和粘滞性,同时接触面的温度应始终低于该非晶合金的晶化温度。
2.
As a result,this can be an evidence that the transformation from the glassy state to supercooled liquid belongs to second-order transition.
利用 DSC 热分析法研究了 Zr 基及78Fe-9Si-13B 非晶合金的热容随温度的变化曲线,发现 Zr 基非晶的热容温度曲线与二级相变热容变化的规律十分相似,因此可以作为玻璃态与过冷液态之间的转变属于二级相变的一个证据。
补充资料：冷态模型试验
分子式：
分子量：
CAS号：
性质：见冷模试验。
分子量：
CAS号：
性质：见冷模试验。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条