1) superheat limit temperature
过热极限温度
1.
The superheat limit temperatures of n-alkane-surfactant-water emulsion systems have been measured by using the liquid column method.
采用液滴注射法测量5种正烷烃(C6-C10)-表面活性剂-水制成乳状液的过热极限温度。
2) superheat limit
极限过热度
1.
The liquid superheat limit and critical radius of bubbles in homogeneous nucleateboiling are determined in the present paper by using density fluctuation theory of statistical theomodynamics.
利用统计热力学密度涨落理论确定了均质沸腾时液体的极限过热度及汽泡的临界半径。
2.
The result is that the theoretical superheat limit of the liquid is the temperature at the critical point.
本文将分子平均自由程的概念引入流体亚稳定状态和理论极限过热度的分析研究,根据分子平均自由程和流体表面张力等特性,分析了气泡生长与分子直径、表面张力的本质关系,得出了流体的理论极限过热温度为其临界温度的结论。
3.
The liquid superheat limit and vapor subcooling limit in homogeneous nucleation are determined in the present paper by using density fluctuation theory of statistical thermodynamics.
应用统计热力学巨正则系综的密度涨落理论 ,提出了确定均质沸腾中液体极限过热度和均质凝结中蒸汽极限过冷度的方法。
3) superheat limit
过热极限
1.
On the basis of these phase diagrams,the superheat limit temperatures of these systems with k_m=0.
9不同条件下刚形成微乳和增溶水量最大时微乳之过热极限。
2.
This paper discusses the mechanism of metastable state of pure substances from the molecular theory and derives the calculation formula of superheat limits of liquid from the cubic equation of state.
从立方形态方程导出液体过热极限的计算公式。
4) limit of superheat
过热极限
1.
The prediction of thermodynamic theoretical limit of superheat;
应用热力学稳定性条件 ,推导得到了二元混和物的稳定性极限条件 ;并把稳定性极限条件应用于三种状态方程中 ,从而得到了其相应的 Spinodal曲线 ;且由 RK方程得到的 Spinodal曲线与实验数值符合较好 ,因此进行正烷烃类混和物的过热极限的热力学理论预测时 ,应选用 RK方程。
5) superheat limits
过热极限
1.
Prediction of homogeneous nucleation superheat limits of pure liquids using molecular interaction model;
用分子相互作用模型预测纯液体的均匀核化过热极限
2.
Theoretical study and prediction of the superheat limits of liquid mixtures;
液体混合物过热极限的理论探讨及其预测
6) Superheating limit
过热极限
1.
The relation between the superheating limits and the critical temperatures was then deduced by applying the P-R equation of state to the limit of stability and the constants of k s expression in the P-R equation of state were further modified.
将P-R状态方程应用到稳定性极限关系式,导出过热极限与临界温度的关系,并修正该状态方程中k表达式中的常数。
2.
Using injection method, the superheating limits of ten systems of binary hydrocarbon mixtures (alkene and alkane or between alkene), which have not been reported, were measured at normal pressure in this thesis.
本文采用注射法测定了常压下烯烃与烷烃以及烯烃之间共十种二元混合物的过热极限。
补充资料:过热蒸汽温度控制
分子式:
CAS号:
性质:过热蒸汽温度控制的目标是维持过热器出口蒸汽温度在工艺允许的范围内,控制手段主要分为两类:(1)通过特殊的烟道挡板来改变流经过热器的烟气量以达到控制过热蒸汽温度的目的;(2)通过安装在蒸汽管线上的减温水流量的改变来控制过热蒸汽温度。
CAS号:
性质:过热蒸汽温度控制的目标是维持过热器出口蒸汽温度在工艺允许的范围内,控制手段主要分为两类:(1)通过特殊的烟道挡板来改变流经过热器的烟气量以达到控制过热蒸汽温度的目的;(2)通过安装在蒸汽管线上的减温水流量的改变来控制过热蒸汽温度。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条