1) roller rectification process
辊矫
1.
By means of analysis of stress and deformation, the mathematic model of of roller rectification process is constructed.
分析了大型材辊矫过程的受力及变形 ,建立了辊矫过程的数学模型。
2) dressing roll
矫直辊、矫正辊
3) pulling-straightening roller
拉矫辊
1.
Thermal-structure coupling analysis of pulling-straightening roller using ANSYS software;
基于ANSYS的连铸机拉矫辊热结构耦合分析
2.
To improve the service life of the pulling-straightening roller in CCM, a new-type compound roller is proposed in this pa- per.
为提高连铸机拉矫辊的使用寿命，提出了新型复合式拉矫辊结构，在对其应力分析的基础上，进行了结构尺寸优化设计，并进行了光弹及热光弹性实验研究。
4) straightener roll
矫直辊
1.
A new processing method of envelope curve surface of straightener roll;
矫直辊包络线曲面加工新方法
2.
The spacial curve is continuous which is formed by straightener roll and tube(bar)tight contact.
矫直辊与管(棒)材紧密接触并形成的空间曲线是连续的,以此曲线为母线绕矫直辊轴线旋转所得的旋转曲面即为矫直辊辊形的曲面。
5) cross-roller
矫直辊
1.
The curve equation and surface equation about the cross-roller are educed and founded by the method of the spatial and analytical vectors, its section equation is an approximate double-curve equation.
采用空间解析几何向量法推导出了矫直辊的辊形曲线方程和曲面方程,其剖面方程是近似的双曲线方程,同时得出了矫直辊的理想曲线是等轴双曲线,利用matlab对推导出的曲线和曲面方程进行了分析绘制以验证结果,为矫直辊曲面力学分析计算及优化设计提供了理论依据。
2.
The curve equation and surface equation about the cross-roller are founded by the method of the spatial and analytical vectors; And the equations are proved and analyzed on mat lab.
本文采用空间解析几何向量法建立了矫直辊的辊形曲线方程和曲面方程:并利用matlab进行了分析验证,本文为矫直辊曲面力学分析计算及优化设计提供了理论依据。
6) Straightening roll
矫直辊
1.
Fracture failure analysis and domestic manufacturing of heavy forged-steel cold straightening roll
大型锻钢冷矫直辊断裂失效分析与国产化
2.
Redesigned straightening roll and parameters have been successfully applied to production.
在开发H800×300产品的过程中,针对设备存在的问题进行了分析和探讨,重新设计了矫直辊,并进行参数设定,该辊已成功应用于生产实践中。
补充资料：矫矫
1.勇武貌。 2.刚强貌。 3.卓然不群貌。 4.高峙貌。 5.飞动貌。 6.昂扬得意貌。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条