1) primary Al_3Fe
初生Al3Fe
1.
The melt treatment by mixing high temperature melt with low temperature melt was adopted to refine the primary Al_3Fe compound.
为细化Al-5%Fe合金中的初生Al3Fe相,研究了高、低温熔体混合工艺对合金组织的影响。
2) primary Al_3Fe phase
初生Al3Fe相
1.
The effect of Mg on the morphology of primary Al_3Fe phase in hypereutectic Al-10%Fe casting alloy was investigated.
研究了Mg元素对铸造Al-10%Fe过共晶合金初生Al3Fe相形态的影响。
2.
The influence of thermal rate treatment on the mechanical property of Al-5%Fe alloy and the morphology of primary Al_3Fe phase was studied.
研究了热速处理工艺对Al 5%Fe合金力学性能和初生Al3Fe相形貌的影响。
3) Al 3Fe
Al3Fe
4) Al_3Fe phase
Al3Fe相
1.
The effect of alloying elements manganese,copper,titanium and boron on the morphology and distribution of the primary Al_3Fe phase in Al-10%Fe alloys was studied.
研究了Mn、Cu、Ti、B等合金元素对Al-10%Fe合金初生Al3Fe相大小、形貌及分布的影响。
2.
The results show that there exists more thick needle-plate like and needle like Al_3Fe phase without superheating and chilling; adding Al-Fe alloy at 1000℃, the microstructure is composed of small needle like iron-rich phases,however, the microstructure becomes coarser when the temperature is too high; the microstructure becomes thinner and thinner with the rise of temper.
研究了在高温过热Al-5%Fe合金熔体中分别加入Al锭和同种成分的Al-Fe合金两种热速处理工艺对Al3Fe相形貌的影响。
5) morphology of Al3Fe
Al3Fe形貌
6) Al3Fe morphology
Al3Fe相形貌
1.
The characteristics of Al3Fe morphology change and the hardness of Al-Fe alloy with various Fe contents were investigated.
研究了不同含Fe量的Al Fe合金中Al3Fe相形貌和Al Fe合金硬度的变化特点。
补充资料：Au-Pd-Cr-Pt-Fe-Al-Y alloys
分子式：
CAS号：
性质：金基与钯、铬、铂、铁、铝和钇的多元合金，电阻系数最高。生产方法参见金钯铬合金。可用作高温应变材料。
CAS号：
性质：金基与钯、铬、铂、铁、铝和钇的多元合金，电阻系数最高。生产方法参见金钯铬合金。可用作高温应变材料。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条