1) Leaking action
泄漏运动
2) leakage flow
泄漏流动
1.
The flange clearance leakage flow and the pressure of vane surface as well as the streamline distribution laws in the case of different cam industrial operation conditions are obtained via the numerical simulation of leakage flow of different flange clearances of the bulb tubular turbine under the different conditions of industrial operation.
通过对灯泡贯流式水轮机在不同工况、不同轮缘间隙的泄漏流动进行数值模拟,得到了不同协联工况下轮缘间隙泄漏流动和叶片表面的压力及流线的分布规律。
2.
Effects of the tip leakage flow of the shrouded rotor blade on the aerodynamic performance of the turbine stage were numerical investigated using commercial CFD software CFX-TASCflow.
采用计算流体动力学软件CFX-TASCflow数值研究了带围带的动叶顶部间隙内泄漏流动对动叶流动效率以及下一级静叶进口气流角的影响特性。
3.
The leakage flow behavior through a brush seal was numerically investigated using the Reynolds-averaged Navier-Stokes solution based on the porous medium model.
采用数值求解基于多孔介质模型的Reynolds-averaged Navier-Stokes方程技术,对刷式密封内泄漏流动特性进行了详细的数值研究。
3) tip leakage flow
泄漏流动
1.
The computed conclusion show that the magnitude of tip clearance has close relationship with the intension of tip leakage flow.
结果表明叶尖间隙的大小与泄漏流动的强度密切相关。
4) dynamic leakage
动态泄漏
1.
According to the displacement response result,the dynamic leakage clearance for the finger seal is obtained and the leakage is subsequently calculated.
为此,对指尖密封动态工作条件下的激励形式和装配过盈进行了技术处理,构建了指尖密封系统的动力学分析模型,获得了指尖密封在转子激励下的位移响应以及动态条件下指尖靴与转子之间的接触压力分布,并根据位移响应结果得到了指尖密封的动态泄漏间隙,建立了指尖密封动态泄漏率计算方法。
6) brake fluid leakage
制动液泄漏
补充资料：南美洲运动会和南十字运动会
1922年在巴西举行过1届南美洲运动会,参加者限于南美洲国家。1978年在玻利维亚举行过 1届南十字运动会，参加国有阿根廷、玻利维亚、巴西、智利、厄瓜多尔、巴拉圭、秘鲁和乌拉圭8国。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条