1) leak to act the electric current
泄漏动作电流
2) leakage flow
泄漏流动
1.
The flange clearance leakage flow and the pressure of vane surface as well as the streamline distribution laws in the case of different cam industrial operation conditions are obtained via the numerical simulation of leakage flow of different flange clearances of the bulb tubular turbine under the different conditions of industrial operation.
通过对灯泡贯流式水轮机在不同工况、不同轮缘间隙的泄漏流动进行数值模拟,得到了不同协联工况下轮缘间隙泄漏流动和叶片表面的压力及流线的分布规律。
2.
Effects of the tip leakage flow of the shrouded rotor blade on the aerodynamic performance of the turbine stage were numerical investigated using commercial CFD software CFX-TASCflow.
采用计算流体动力学软件CFX-TASCflow数值研究了带围带的动叶顶部间隙内泄漏流动对动叶流动效率以及下一级静叶进口气流角的影响特性。
3.
The leakage flow behavior through a brush seal was numerically investigated using the Reynolds-averaged Navier-Stokes solution based on the porous medium model.
采用数值求解基于多孔介质模型的Reynolds-averaged Navier-Stokes方程技术,对刷式密封内泄漏流动特性进行了详细的数值研究。
3) tip leakage flow
泄漏流动
1.
The computed conclusion show that the magnitude of tip clearance has close relationship with the intension of tip leakage flow.
结果表明叶尖间隙的大小与泄漏流动的强度密切相关。
4) Leakage Current
泄漏电流
1.
A simple method of detecting leakage current to ground;
一种简易的对地泄漏电流的检测方法
2.
Technological analysis of measuring leakage current under condition of exerting DC voltage on winding ends for 200MW generator stator windings;
200MW发电机定子绕组端部施加直流电压下泄漏电流测量的技术分析
5) leak current
泄漏电流
1.
Design of on-line monitoring for leak current of insulating casing;
绝缘套管泄漏电流在线检测单元设计
2.
The average leak current is less than 0.
5V(DC)条件下测得的泄漏电流平均值不大于0。
6) leakage current
漏泄电流
1.
Adding a appropriate amount of SiO2 to ZnO ceramics leads to incrcase a value and voltage gradient of the varistor, to decrease leakage current and to raise withstanding surge current, that results in making ZnO varistors with excellent performance.
实验研究了ＳｉＯ２对ＺｎＯ压敏电阻器性能的影响，在ＺｎＯ陶瓷中，添加适量的ＳｉＯ２可以提高压敏电阻器的α值和电压梯度，降低漏泄电流，提高通流量，能够制造出性能优异的ＺｎＯ压敏电阻器。
补充资料：泄漏电流
分子式：
CAS号：
性质：沿不希望的绝缘途径流过的电流。泄漏电流由泄漏电流试验测定。泄漏电流试验一般是直流泄漏电流试验。泄漏电流试验可发现绝缘物的硬伤、脆裂等缺陷。发电机、交流电动机、变压器和电抗器、油断路器和空气断路器、电力电缆、避雷器等高压设备投入运行前应按规定做泄漏电流试验。绝缘手套、绝缘靴、绝缘垫等电工安全用具亦应按规定，定期做泄漏电流试验。
CAS号：
性质：沿不希望的绝缘途径流过的电流。泄漏电流由泄漏电流试验测定。泄漏电流试验一般是直流泄漏电流试验。泄漏电流试验可发现绝缘物的硬伤、脆裂等缺陷。发电机、交流电动机、变压器和电抗器、油断路器和空气断路器、电力电缆、避雷器等高压设备投入运行前应按规定做泄漏电流试验。绝缘手套、绝缘靴、绝缘垫等电工安全用具亦应按规定，定期做泄漏电流试验。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条