1) Servo driver
伺服驱动器
1.
Control interface between servo drivers and DeviceNet fieldbus;
伺服驱动器的Device Net控制接口
2.
This paper has studied RS-485 communication technology of Panasonic servo driver has realized that a PC could control several servo motors has used the C language to elaborate its programming method and the process.
研究了伺服驱动器的RS-485通讯技术,实现了一台PC机控制多台伺服电机,利用C语言阐述了其编程方法和过程,结果表明控制伺服电机可行。
3.
The design of the motor servo driver based on Intelligent Power Module (IPM) was introduced in this paper; its working principle, hardware frame and the design of the PWM (Pulse Width Modulation) servo amplifier were clearly presented.
介绍了基于智能功率模块的电机伺服驱动器的设计、工作原理、硬件结构及脉宽调制 (PWM )伺服放大器的设计方法 ,并将此驱动器应用于多种运行情况下的实验 ,同时对所提出的新型控制算法———自抗扰控制 (ADRC)进行了实验验证 。
3) servo driver/servo motor
伺服驱动器/伺服电机
1.
The system consisted of PLC,touch panel,frequency converter,servo driver/servo motor and other components.
系统以可编程控制器(PLC)为核心,还包括触摸屏、变频器、伺服驱动器/伺服电机等部件。
4) AC servo driver
交流伺服驱动器
1.
This paper introduces the communication protocols of MicroLogix series PLC and AC servo drivers,which achieves serial communication between PLC and AC servo drivers.
对Micrologix系列PLC和交流伺服驱动器的通信协议进行了详细的介绍,并以RSLogix500为开发工具实现了PLC与交流伺服驱动器的串行通信。
5) AC servo drive
交流伺服驱动器
1.
A low voltage AC servo drive based on TMS320F2812;
一种基于TMS320F2812设计的低压交流伺服驱动器
补充资料：伺服电机和减速器的选择
1,确认您的负载额定扭矩要小于减速机额定输出扭矩，
2,伺服电机额定扭矩*减速比要大于负载额定扭矩。
3，负载通过减速机转化到伺服电机的转动惯量，要在伺服电机允许的范围内。
4，确认减速机精度能够满足您的控制要求。
5，减速机结构形式，外型尺寸既能满足设备要求，同时能与所选用的伺服电机连接。
2,伺服电机额定扭矩*减速比要大于负载额定扭矩。
3，负载通过减速机转化到伺服电机的转动惯量，要在伺服电机允许的范围内。
4，确认减速机精度能够满足您的控制要求。
5，减速机结构形式，外型尺寸既能满足设备要求，同时能与所选用的伺服电机连接。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条