1) hydrogen-induced martensite
氢致马氏体
1.
Hydrogen-induced delayed fracture during dynamic charging of TiNi shape memory alloy, and the role of atomic hydrogen, hydrogen-induced martensite and hydride in hydrogen-induced delayed fracture have been investigated.
用单边缺口拉伸试样研究了TiNi形状记忆合金在恒载荷下动态充氢时的滞后断裂过程,以及原子氢、氢致马氏体和氢化物在氢致滞后断裂中所起的作用。
2.
Susceptibility to stress corrosion cracking (SCC) for the specimens with various hydrogen-induced martensite was measured by slow strain rate tests in a MgCl2 solution and in silicon oil at 143℃, respectively.
通过电解充氢后除气,即可在304奥氏体不锈钢中引入不同数量的氢致马氏体（ε+α’,其中ε占 2/3）;同时并未明显改变试样的强度和位错密度。
3.
The morphology of stress-induced martensite and hydrogen-induced martensite is similar and could not be distinguished.
研究了近等原子比NiTi形状记忆合金在阴极充氢后时效过程中表面的相变与破坏,认为时效裂纹的产生与奥氏体不锈钢类似,为氢释放和氢致马氏体分解导致表面收缩产生较大张应力所致,时效过程中裂纹扩展持续时间超过5天。
2) hydrogen induced martensite transformation
氢致马氏体相变
3) thermal martensite
热致马氏体
1.
The crystal structure of thermal martensite is determined to be hcp, with the lattice parameters being a=0.
结果表明,Co-Ni合金均匀化退火后其热致马氏体为密排六方结构,点阵参数为a=0 251nm,c=0 407nm,热轧后马氏体组织呈透镜状。
4) martensite
[英]['mɑ:tən,zait] [美]['mɑrtən,zaɪt]
马氏体
1.
Effect of deformation on the temper process of lath martensite;
形变对板条马氏体回火组织的影响
2.
Cold rolling deformation and recrystallization behavior of martensite Ni_(40.5)Co_(32.5)Al_(27) alloy;
Ni_(40.5)Co_(32.5)Al_(27)马氏体合金的冷变形和再结晶行为
3.
Influence of heat treatment on the properties of the heat-resistance martensite stainless steel 0Cr_(17)Ni_4Cu_4Nb;
热处理对耐热马氏体不锈钢0Cr_(17)Ni_4Cu_4Nb性能的影响
5) martensitic steel
马氏体钢
1.
The microstructure and mechanical properties of China low activation martensitic steel;
低活化马氏体钢的微观结构与力学性能
2.
Introduces forging technology and matters needing attention of valve of martensitic steel 4Cr 10 Si 2Mo, analyses the reason that the steel can ’t be cooled by air, compares forging characteristics with valve of austenitic steel 4Cr 14 Ni 14 W 2Mo and come to the feasiblity of new technology of valve adopting direct extrusion.
介绍了马氏体钢４Ｃｒ１０Ｓｉ２Ｍｏ气阀的锻造工艺及生产中的注意事项，分析了这种钢不能采用空冷的原因，并且与奥氏体钢４Ｃｒ１４Ｎｉ１４Ｗ２Ｍｏ气阀的锻造特点进行了比较，提出了气阀生产新工艺———正挤压的可行性。
3.
n this research, the characteristic of martensitic steel in abrasion was investigated by using three different test methods.
９８％４种合碳量马氏体钢的磨料磨损特性进行了考察。
6) Half-martensite
半马氏体
补充资料：马致远
| 马致远(约1250～约1324) 中国元代戏曲作家，散曲家。号东篱，一说字千里。大都 ( 今北京 )人。曾任江浙行省官吏，仕途不得志，后归隐山林。著有杂剧15种，今存《破幽梦孤雁汉宫秋》、《江州司马青衫泪》、《 西华山陈抟高卧 》、《 吕洞宾三醉岳阳楼》、《马丹阳三度任风子》、《半夜雷轰荐福碑》以及与人合写的《邯郸道省悟黄粱梦》等 7 种。代表作《汉宫秋》取材于汉代王昭君和亲故事，但情节有较大改动，以汉元帝和王昭君的爱情为主线，同时揭露了汉朝君臣的昏庸和无能，塑造了王昭君这一爱国者的形象。这一形象成为后来戏曲中汉明妃的定型。马致远的散曲今存 120多首，成就为元人之冠。作品内容主要有叹世、咏景、恋情3类。声调和谐优美、语言清新豪爽，善于捕捉形象来熔铸诗的意境，提高了曲的格调，对散曲的发展与提高作出了贡献 。其[双调夜行船]套曲 、[天净沙]“枯藤老树昏鸦”等历来被人推为元代散曲中的极品。今人任中敏辑有散曲集《东篱乐府》。
|
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条