1)  rotary test
旋转测试
2)  mental rotation test
心理旋转测试
3)  rotation
旋转
1.
A Possible Mechanism of α Subunit 'Push' γ-Subunit Rotation in ATPase;
ATP合酶中α亚基推动γ亚基旋转的可能机制
2.
Successful experiences of rotation mining method at combined mining face;
综采工作面旋转采煤法成功经验
3.
Measurement of the rotational alignment of the distal femur with 3-dimensional CT;
三维螺旋CT重建股骨远端旋转力线的测量
4)  rotate
旋转
1.
The experimental results show that it can eliminate the phenomena of zigzag caused in image rotation and reduce the image distortion after image rotates many times.
图象旋转是图象处理中的一个基本操作,根据图象在邻近区域内连续的特点,该文提出一种基于高斯模板的图象旋转算法。
2.
Let P and Q be two nonintersecting simple polygons in the plane, this paper discusses the rotational movability of them if P rotates around a point and collides with Q .
设 P和 Q为平面内两个互不相交的简单多边形 ,若 P在平面内绕某点旋转 ,文中讨论了其旋转可移动性问题 。
5)  rotating
旋转
1.
Heat transfer performance of!heat pipe rotating about parallel axes;
平行轴旋转热管传热性能的实验
2.
Experimental investigations on the local heat transfer coefficient of rotating single circular impingement in a half-limited space;
旋转半受限单孔冲击局部换热特性实验
3.
Local heat transfer in a rotating U-shaped square channel with three channel orientations;
3种转角下旋转U形方通道的局部换热
6)  rotary
旋转
1.
Introduction of static bias push-the-bit rotary naviyational system;
静态偏置推靠钻头式旋转导向钻井系统介绍
2.
Improvement & application of rotary self-seal assembly in workover job;
旋转自封封井器在大修作业中的技术改进及应用
3.
Brief discussion on fully mechanized rotary mining method with hydraulic powered support;
综采支架旋转采煤法初探
参考词条
补充资料:测试结果可接受性的检查和最终测试结果的确定


测试结果可接受性的检查和最终测试结果的确定
check of the acceptability of test results and determination of the final test result

  C凡(3)二3.3d,时,取此3个结果的平均值作为最终侧试结果;否则取它们的中位数作为最终测试结果。。,为重复性标准差(即在重复性条件下所得侧试结果的标准差)。 在口田T 11792一1989中还对重复性和再现性条件下所得侧试结果可接受性的检查方法和最终测试结果的确定做了详细讨论和规定。(马毅林)ceshi 11叩uo kejieshCxjxing d6 iiancha he zuizhong ceshi】i闪旧de que心ing测试结果可接受性的检查和最终测试结果的确定(checkof山eac,ptability of test,ults助ddsterminationofthefi耐testresult)在商品检验中进行一次测试的情形不多见,当得到一个测试结果时,所得结果不可能直接与给定的重复性标准差作可接受性的检查。对测试结果的准确性有任何疑问时都应再进行一次测试。所以,对两个测试结果进行可接受性的检查是一般的情况。 可接受性的检查,实际上是一种统计检验。任何两个测试结果只要能通过可接受性的统计检验即可认为是一致的,均可接受。比如,在重复性条件下,所得结果之差的绝对值(下称绝对差)不超过相应的重复性限r(见重复性和再现性)的值,则认为两个结果是一致的,均可接受;如果两个侧试结果的绝对差超过r,则认为它们是不一致的,必须增加测试。 按国家标准《测试方法的精密度在重复性或再现性条件下所得测试结果可接受性的检查和最终测试结果的确定》(GBIT 1 1792一1989),在重复性条件下,如果两个测试结果的绝对差不超过r的值,可取两个侧试结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较低,须再做两次测试。当4个结果的极差(即其中的最大值与最小值之差)不超过相应的临界极差c,瓜(4)二3.6a,时,取4个结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较高时,只须再作一次测试。当3个结果的极差不超过相应的临界极差
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。