1)  In situ FTIR
原位FTIR光谱
2)  in situ
原位
1.
Research progress on enhancement of in situ remediation of heavy metal by electrokinitics;
重金属污染土壤的电动原位修复技术研究
2.
Investigation of mechanical properties and damping capacity of in situ TiB_2/7055 composites;
原位TiB_2/7055铝基复合材料的力学性能与阻尼性能
3.
Conductive polyaniline/chlorosulfonated polyethylene composites prepared by in situ emulsion polymerization and their properties;
原位乳液聚合制备导电性聚苯胺/氯磺化聚乙烯复合材料及其性能
3)  orthotopic
原位
1.
Urodynamical examination of orthotopic ileal neobladder with laparoscopic radical cystectomy;
腹腔镜下膀胱全切除、原位回肠新膀胱的尿流动力学分析
2.
The clinical management of cardiovascular complications after orthotopic liver transplantation;
原位肝移植术后心血管并发症的临床处理
3.
Establishment of multidrug resistance in a model of orthotopic transplantation of human hepatocellular carcinoma in nude mice and study on the mechanism of multidrug resistance;
裸鼠人肝癌原位移植多药耐药模型的建立及其耐药机制的探讨
4)  In-situ
原位
1.
Improving Tribological Properties of Metal Materials Based on in-situ Tribochemical Treatment Technique;
基于原位摩擦化学处理技术改善金属材料的摩擦学性能
2.
Biodiesel from Rapeseed via Extraction and in-situ Transesterification in Supercritical Methanol;
油菜籽与超临界甲醇原位萃取-酯交换反应制备生物柴油
3.
A novel strategy to fabricate in-situ surface reinforced metal composite;
原位制备表面增强复合材料的一种新方法
5)  in-situ reaction
原位反应
1.
Preparation of polyester/nano-ZnO composites by in-situ reaction;
原位反应合成聚酯/纳米氧化锌复合材料
2.
Fabrication of Al_2O_3-TiC/Al Composites by In-situ Reaction;
原位反应法制备Al_2O_3-TiC/Al复合材料
3.
In-situ reaction and phase composition design of monolithic refractories;
不定形耐火材料中的原位反应与相组成设计
6)  in situ polymerization
原位聚合
1.
Preparation of microcapsules for electrophoretic display via in situ polymerization of urea-formaldehyde;
一步原位聚合法制备电泳显示微胶囊的研究
2.
Unsaturated polyester resin(UP) /kaolinite intercalation nanocomposites were prepared by in situ polymerization through UP replacing DMSO in kaolinite/ DMSO intercalation usher,which was prepared by sonochemistry technique.
利用超声法制备了高岭土-DMSO插层复合物前驱体,采取二步取代,原位聚合制备了不饱和聚酯树脂/高岭土纳米复合材料,并用XRD、FT-IR等手段对材料结构进行了表征,研究了纳米复合材料的阻燃性能。
3.
Polyamide 6(PA6)/silica nanocomposite was prepared by using tetraethoxysilane(TEOS) as precursor and 3-glycidoxypropyltrimethoxysilane(WD-60) as modifier through in situ polymerization.
以正硅酸乙酯(TEO S)为前驱体,环氧丙基三乙氧基硅烷(W D-60)为改性剂,经原位聚合制备PA 6/S iO2纳米复合材料。
参考词条
补充资料：电化学原位红外光谱法
分子式：
CAS号：

性质：红外光谱法检测灵敏度高，具有“指纹”性的谱段，对于确认电化学反应过程的中间体以及了解吸附物种的状态特别有利。但是由于信号微弱，信噪比低，特别是电化学中常用的水溶液对红外线吸收强烈，使用困难较多。直至20世纪80年代，陆续采用了一些新技术，如光学电解池的聚乙烯红外窗及1～100μm薄层电解液，红外光谱的傅里叶变换技术、偏振调制技术和扫描干涉仪等，发展了如SNIFTIRS，EMIRS，IRRAS等方法，在电化学动力学、电催化、化学电源等许多方面已获得有意义的成果。

说明：补充资料仅用于学习参考，请勿用于其它任何用途。