1) design of cutting edge
刃口设计
3) Edge
[英][edʒ] [美][ɛdʒ]
刃口
1.
The influences of flank surface and edge quality of PCD cutting tool on cutting surface quality when machining nonferrous metal are studied in this paper.
本文主要研究PCD刀具加工有色金属时刃口及后刀面的刃磨质量对切削表面质量的影响。
2.
In the CAD for blanking die,how to correctly discriminate the dimension types of the edge is a key work.
在冲裁模刃口尺寸的计算机辅助设计中，正确地识别尺寸类型是设计、计算最关键的一步。
3.
A Series of the standard edge samples made of 45,60 and GCr15 steels is prepared to test sharpness in the process of cutting.
用４５钢、６０钢和ＧＣｒ１５钢制成标准刃口进行切割锋利度试验。
4) blade
[英][bleɪd] [美][bled]
刃口
1.
Through two kinds of technologies on trimming die of automobile cover parts introduced, the technology and characteristic of die blade were introduced by using repair welding.
通过对汽车覆盖件修边模模块两种加工工艺的介绍,阐述用堆焊焊条堆焊出凸凹模模块刃口的工艺过程及其特点,对中小规模的相关行业的模具制作和维修有较好的借鉴和参考价值。
5) Die design
口模设计
1.
After an analysis on the velocity distribution obtained from numerical simulation, the original die design was modified;and the length of each part of molding zone was determined according to the principle of flow rate equilibrium.
研究还表明:对于异型材挤出口模设计,不能把口模截面视作若干规则形状截面的简单几何组合,必须把其当成一个整体来对待;过渡区不仅影响成型区的流动,而且对稳流区的流动也有不可忽视的影响,设计时应对过渡区给予足够的重视。
2.
The gas-assisted extrusion,fiber spinning,hollow fiber and microporous membrane technology were contacted for the first time,and the actuality of these technologies and the characteristics of die design were introduced breifly at home and abroad.
首次将气辅挤出、纤维纺丝、中空纤维及微孔薄膜技术联系起来,并简要介绍了国内外这些技术的研究现状和口模设计的特点。
6) Interface design
接口设计
1.
The Interface Design of Matlab and VC;
Matlab与VC的接口设计
2.
Serial communication interface design between DSP and PC;
PC机与DSP串行通信接口设计
3.
A Practical Interface Design of VXI Bus;
一种实用的VXI总线接口设计
补充资料：1350mm双流板坯连铸机(重庆钢铁设计研究院设计)
1350mm双流板坯连铸机(重庆钢铁设计研究院设计)
叠 135Omm双流板坯连铸机(重庆钢铁设计研究院设计)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条