1.
EDG Technology of PCD Tool with Internal Cutting Edges
内凹刃口PCD刀具电火花刃磨工艺
2.
That knife has a sharp edge.
那把刀的刃口锋利。
3.
Relationship between microstructure and properties and failure mechanism of knife-edge with small angle
薄刃刀具刃口失效机制与材料组织性能的关系
4.
Some have as few as two cutting edges and others have 30 or more.
有些铣刀只有两个刃口,而有些铣刀却有三十或更多的刃口。
5.
As the tool softens due to heat, it wears and Breaks down at the cutting edge or face.
在刃口因高温而软化的同时,刀具刃口便开始磨耗并损坏。
6.
with the edge forward or on, by, or toward the edge.
刃口朝前，在边上，从边上，向边上。
7.
The blade of this shape is very rigid and sharp!
倘有，这型制之刃口是特别硬及?利的！
8.
Experiment and Numerical Simulation of Laser Quench on Die Blade
模具刃口的激光淬火试验与数值模拟
9.
Influence of Drill's Edge Preparation on Drilling of 42CrMo
钻头刃口处理对钻削加工42CrMo的影响
10.
He could make a tool with a sharp edge for cutting.
人能用青铜做成一种刃口锋利的切削工具。
11.
The convenient handwheel adjustment of cutting edge clearance is rapid and precise as well.
◆ 矩形刀片，四个刃口均可使用，使用寿命长。
12.
Finite Element Simulation of Influence of Tool Edge Radius in Micro-milling
微铣削加工刀具刃口半径影响的有限元模拟
13.
Discussion about the Continuity of Arc-shaped Curve of Ball-end Milling Cutting
等螺距圆弧形球头铣刀刃口曲线的连续性讨论
14.
Arc-shaped Curve of Ball-end Milling Continuity
柱状球头回转铣刀的等螺距刃口曲线研究
15.
Check the blade grinds as above. Daggers are often challenging in this regard.
如同上面折叠刀介绍的方法检查刃口打磨。短剑在刃磨方面比较有挑战性。
16.
The cutting edge radius of the tools is minimized less than0.05μ m and the radius waviness of the tools is improved no more than0.2μ m.
刃磨出的金刚石刀具刃口半径值可以达到0.05μ以下，刀尖圆弧圈度提高到0.2μ以内。
17.
Clean the shave after each use to keep the cutting edge sharp.
每次使用完后要清理电动剃须刀以保持刃口锋利。
18.
As a tool cuts, high heat is developed as a result of compression and friction at the cutting edge of the tool.
当刀具进行切削时,刀具刃口处的压力和摩擦导致了高热。