1) jar test
烧杯试验
1.
This method can obtain the optimum coagulant,shoot the optimum adding amount,design the best flocculates time through jar test,and utilize orthogonal experiment to seek the best energy consumption allocative decision at different levels.
提出了混凝工艺设计的优化方法,通过烧杯试验得到最优混凝剂和最佳投加量以及最佳设计絮凝时间,并利用正交试验寻求多因素不同水平组合下的最佳能耗分配方案。
2.
This text has proposed the optimization method to coagulation G and T design;receives the optimum coagulant and shoots the adding amount and optimum design and flocculation time bestly through the jar test;and utilize and hand in the test and seek to make the best G and T decision under the multifactor different levels.
通过烧杯试验得到最优混凝剂和最佳投加量以及最佳设计絮凝时间,并利用正交试验寻求多因素不同水平组合下的最佳G和T分配方案。
2) beaker test
烧杯试验
1.
Comparisons between the said model test and the beaker test using mechanical agitation were made and the test results were analyzed to find the advantages and disadvantages of each of the two types of agitation methods.
针对压缩空气搅拌混凝工艺在污水处理上的广泛应用,用模型试验来确定压缩空气搅拌反应的最优条件;通过该模型试验与机械搅拌下的烧杯试验进行比较,对试验结果进行分析得出两类搅拌方式的优缺点。
2.
By means of static beaker test and dynamic simulation test, the effects of Al 2(SO 4) 3, PAC, PHS and HPAM of treating simulated wastewater are evaluated.
对硫酸铝、聚合铝 (PAC)、聚合铁 (PFS)和部分水解聚丙烯酰胺 (HPAM)等 4种混凝剂处理模拟污水的效果分别进行了静态烧杯试验和动态模拟试验评价 。
3.
Through a large number of beaker tests,we have compared their purifying effects and economic worth,and bioflocculation is better.
通过大量的烧杯试验,对各种混凝剂的净水效果及经济价值进行比较,同时,也对混凝沉淀后滤后水做了一些研究。
3) sintering pot test
烧结杯试验
1.
In this paper,sintering fundamental characteristics of FMGF ore fines is compared with those of the two Australian ores named as HIXF and HIYF,on the basis of which sintering pot test plan is worked out.
在测定FMG矿粉与哈默斯利矿粉HIXF及HIYF烧结基础特性的基础上,通过比较分析,制定了烧结杯试验方案,以考察FMG矿粉取代HIXF及HIYF对首钢烧结生产技术指标的影响。
2.
In this paper,sintering fundamental characteristics of FMG ore fines is compared with those of the two Australian ores named as HIXF and HIYF,on the basis of which sintering pot test plan is worked out.
在测定 FMG 矿粉与哈默斯利矿粉 HIXF 及 HIYF 烧结基础特性的基础上,通过比较分析,制定了烧结杯试验方案,考察 FMG 矿粉取代 HIXF 及 HIYF 对烧结生产技术指标的影响：烧结矿品位增加,SiO_2含量降低,Al_2O_3 含量变化明显；烧结矿成品率上升,固体燃耗下降,烧结矿 RDI 指标有所改善。
4) sinter pot test
烧结杯试验
1.
The application of WinCC to the Sinter Pot Test Supervisory System
WinCC在烧结杯试验监控系统中的应用
2.
This paper gives an introduction to the hardware and software configuration of the sinter pot test supervisorysystem,the sinter pot test supervisory system based on S7-300PLC and WinCC soft is described in detail.
介绍了烧结杯试验监控系统的硬件配置和软件组成,重点讨论了基于S7-300系列PLC及WinCC软件开发的烧结杯试验监控系统。
5) jar test
瓶试验，烧杯试验
6) Sintering cup laboratory
烧结杯试验室
补充资料：烧杯试验
分子式：
CAS号：
性质：在澄清处理含悬浮固体低于5000mg/L的原水或污水之前所进行，旨在测定水的PH和估计澄清所需化学药品最佳剂量而进行的实验室试验。将不等量的处理剂分别加于置入烧杯中的若干个等体积的水样中，经缓慢搅拌后静置沉降。对形成的矾花和上层清液进行分析测定，以确定最佳的药剂加量。
CAS号：
性质：在澄清处理含悬浮固体低于5000mg/L的原水或污水之前所进行，旨在测定水的PH和估计澄清所需化学药品最佳剂量而进行的实验室试验。将不等量的处理剂分别加于置入烧杯中的若干个等体积的水样中，经缓慢搅拌后静置沉降。对形成的矾花和上层清液进行分析测定，以确定最佳的药剂加量。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条