1) nickel-graphite
镍石墨
2) nickel coated graphite
镀镍石墨
1.
Preparation and properties of nickel coated graphite/methyl vinyl silicone rubber electric conductive composites;
镀镍石墨/甲基乙烯基硅橡胶导电复合材料的制备与性能
3) nickel-coated graphite
镍包石墨
1.
In order to improve wear resistance of titanium alloy,a CO2 laser was used to clad coating onto TC4 alloy substrate with pre-placed nickel-coated graphite powder.
为了提高钛合金的表面耐磨性能,采用MXP-2000型销盘式摩擦磨损实验机,以镍包石墨粉末为原材料,利用CO2激光器在TC4合金表面上熔覆耐磨涂层,进行钛合金及激光熔覆涂层的干摩擦磨损实验,并用扫描电镜对磨损表面进行观察和分析。
2.
The self-lubricanting coating of nickel-coated graphite was prepared by oxygen-acetylene flame spraying technology and its friction and wear properties at room temperature were studied in a ball on disk test rig.
选用镍包石墨粉末,采用氧-乙炔火焰喷涂技术制备镍包石墨自润滑涂层,在球-盘摩擦磨损试验机上探讨了室温条件下镍包石墨自润滑涂层的摩擦磨损性能。
4) Ni/C
镍包石墨
1.
Study on Friction and Wear Properties of Ni/C Self-lubricanting Coating;
镍包石墨自润滑涂层摩擦磨损性能研究
2.
Self-lubricant (SL ) coating was prepared by oxy-acetylene flame spraying using Ni/C.
选用镍包石墨粉末,采用氧-乙炔焰喷涂技术制备镍包石墨自润滑涂层。
5) interface of nickel-carbon/ethanol
镍-石墨/乙醇
6) graphite coated with nickel
镀镍石墨粉
1.
Effect of graphite coated with nickel on mechanical properties of copper-matrix/graphite composite materials;
镀镍石墨粉对铜基石墨复合材料力学性能的影响
补充资料：银镍石墨合金
分子式：
CAS号：
性质：银基添加镍和石墨的三元合金，具有自润滑作用。如AgNiCl0-2合金的密度9.38g/cm3。洛氏硬度26。采用粉末冶金方法制造。中等负荷开关电器用复合电接触材料，如接触器、开关、继电器的接点。
CAS号：
性质：银基添加镍和石墨的三元合金，具有自润滑作用。如AgNiCl0-2合金的密度9.38g/cm3。洛氏硬度26。采用粉末冶金方法制造。中等负荷开关电器用复合电接触材料，如接触器、开关、继电器的接点。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条