1)  stainless steel plate
不锈钢板片
1.
The results i ndicted that the failure of the stainless steel plates was mainly due to crevice corrosion induced by Cl-.
利用光学显微镜、扫描电镜、电子能谱等测试手段,从材料成分、微观组织、断口形貌以及腐蚀产物成分等角度,分析了板式换热器不锈钢板片穿孔泄漏的原因。
2)  stainless
不锈
1.
To set forth using circumstance, type number comparison, corrosion type and anti-corrosion capability, process 6f stainless well-measuring steel wire and compare lots of data.
通过对不锈录井钢丝的使用环境、国内外牌号对比、腐蚀类型及其耐蚀能力、工艺等的叙述和大量数据的对照,提出选用不锈录井钢丝的经验公式和选择要求,指导不锈录井钢丝的生产、选用。
3)  stainless steel
不锈钢
1.
Vacuum hot roll bonding of TC4 titanium alloy and 0Cr18Ni10Ti stainless steel;
TC4钛合金与0Cr18Ni10Ti不锈钢真空热轧连接
2.
Research on cyclic ion nitriding technology catalyzed by rare earth for 2Cr13 stainless steel;
2Cr13不锈钢的稀土催渗循环离子渗氮工艺研究
3.
Analysis of the components of acid chemical coloring solutions for stainless steel;
不锈钢酸性化学着色液成分的分析方法
4)  2Cr13 stainless steel
2Cr13不锈钢
1.
The study showed that heat transfer performance of mold fluxes for 2Cr13 stainless steel.
采用DIL402C热膨胀分析仪、STA449C同步热分析仪和Gleeble—1500D热模拟试验机,分别测试2Cr13不锈钢的线性膨胀系数、主要相变温度以及高温力学性能等高温特性,分析2Cr13不锈钢高温性能对铸坯表面质量的影响和铸坯表面凹陷以及微裂纹产生的机理,确定2Cr13不锈钢用保护渣应重点考虑传热性能。
2.
2Cr13 stainless steel was quenched in water and the influence of quenching temperature on microstructre and performance was studied.
对2Cr13不锈钢进行水淬火实验,研究了淬火温度对2Cr13不锈钢组织和性能之间的关系,发现在1050℃淬火时,试样的硬度值基本达到了最高,其原因是因为碳化物大多被溶解,铁素体的含量已经非常低。
3.
Surface modification of 2Cr13 stainless steel was carried out using plasma immersion ion implantation (PIII) combined with ion beam enhanced deposition (IBED) technique.
对 2Cr13不锈钢表面进行了等离子体浸没离子注入(PIII)与离子束增强沉积(IBED)复合强化处理。
5)  1Cr13 stainless steel
1Cr13不锈钢
1.
Vacuum brazing between TiC/NiCr cermets and 1Cr13 stainless steel;
TiC/NiCr金属陶瓷与1Cr13不锈钢的真空钎焊
2.
Titanium coating had been deposited on 1Cr13 stainless steel substrate using cold spray technique.
0MPa,载气温度为500℃的状态下,用冷喷涂的方法在1Cr13不锈钢基体上制备了钛金属涂层。
3.
TiC/Ti(C, N)/TiN multi-layer coatings are prepared on the 1Cr13 stainless steel substrate by the technique of Chemical Vapour Deposition, and the fretting wear behaviour of 1Cr13 stainless steel and TiC/Ti(C, N)/TiN coatings are investigated and studied contrastively from 25℃ to 400℃ in the gross slip regime.
采用化学气相沉积(CVD)技术,在1Cr13不锈钢基体上制备TiC/Ti(C,N)/TiN复合涂层。
6)  254SMo stainless steel
254SMo不锈钢
参考词条
补充资料:氨酚伪麻片(日片)与氨苯伪麻片(夜片)
药物名称:氨酚伪麻片(日片)与氨苯伪麻片(夜片)

英文名:Compound paracetamol Combination Tablets

汉语拼音:

主要成分:日服片:对乙酰氨基酚、盐酸伪麻黄碱;夜服片:对乙酰氨基酚、盐酸伪麻黄碱、盐酸苯海拉明。

性状:日服片为白色,夜服片为蓝色。

药理作用:动物试验表明本品具有解热、镇痛、镇静作用,另可降低鼻气道阻力及粘膜血管的通透性。

药代动力学:

适应症:用于治疗感冒引起的发热、头痛、四肢疼痛、鼻塞、流涕、喷嚏等症状。

用法与用量: 白天服日服片,每日二次(8小时一次),每次1~2片。
晚上睡前服用夜服片,一日一次,每次1片。

不良反应:偶见。为轻度口干、口苦、上腹不适、困倦、多汗等。

禁忌症:对(包括日服片和夜服片)组分过敏者禁用。

注意事项: 1.每日不超过8片,疗程不超过7天。超量服用可产生头晕、失眠、神经质等症状。
2.心脏病、高血压、甲亢、糖尿病、青光眼、肺气肿等呼吸困难、前列腺肥大伴排尿困难者不宜服用。
3.避免与降压药或抗抑郁药同时服用,服药期间避免饮酒。
4.孕妇、哺乳期妇女使用前应咨询医生。
5.服用本品若症状未改善或伴高热,应及时停药。
6.对麻黄碱药理作用敏感者及老年人慎用。12岁以下儿童不宜服用。
7.夜用片服药期间可引起头晕、嗜睡,故不宜驾车、高空作业及操纵机器。

规格:每片含 日服片 夜服片
对乙酰氨基酚 0.325g 0.5g
盐酸伪麻黄碱 30mg 30mg
盐酸苯海拉明

贮藏:遮光,密闭保存。

有效期:暂定二年。

处方药:
说明:补充资料仅用于学习参考,请勿用于其它任何用途。