说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 两体磨损
1)  Two body wear
两体磨损
2)  two kinds of losses
两种磨损
3)  wear volume
磨损体积
1.
The relationships between the amounts of graphite addition and graphite eutectoid,voltage and graphite eutectoid amount,graphite addition amount and microhardness,and graphite addition amount and wear volume were discussed.
采用电刷镀技术制备了N i-石墨颗粒复合镀层,给出了N i-石墨复合电刷镀的工艺流程和镀液配方,讨论了石墨添加量与石墨共析量、电压与石墨共析量、石墨添加量与显微硬度、石墨添加量与磨损体积之间的关系。
2.
The effects of normal load,vibration amplitude and frequency on friction coefficient and wear volume were analyzed.
利用微动磨损试验机研究7A52铝合金的微动磨损行为,分析不同载荷、振幅、循环次数等参数对摩擦因数和磨损体积的影响,观察分析不同振幅下的磨痕形貌,检测磨痕微区及磨粒的成分组成,探讨其磨损机制。
4)  three-body abrasion
三体磨损
1.
The results show that the wear volume of Ti6Al4V alloy is gradually increased with the increase of load,sliding distance and slurry concentration,and the tribological mechanism is transformed from three-body abrasion to .
结果表明:随载荷、滑行距离和料浆浓度的增加,Ti6Al4V合金的磨损量增加,磨损机制由三体磨损转变为混合磨损。
5)  matrix wear intensity
胎体磨损
6)  three body abrasion
三体磨损
1.
Monte Carlo method was applied for simulating plastic deformation wear rate of materials under the three body abrasion using ball like abrasive particles.
根据三体磨损是典型的随机过程这一特点 ,运用蒙特卡罗方法模拟在球形磨料的作用下 ,材料塑性变形磨损的磨损率 。
2.
The rationality of the tribological terms such as two body abrasion and three body abrasion was discussed and the relation between two body abrasion and three body abrasion was examined through the reported experimental results.
通过对二体磨损和三体磨损的概念的讨论以及二体磨损和三体磨损关系的分析 ,提出了二体磨损是三体磨损的特例 ,三体磨损更具有普遍性这一观点。
补充资料:两体
1.犹两形。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条