1) block polyether acidamide resin
嵌段聚醚酰胺树脂
1.
Recently , a kind of block polyether acidamide resin with the trade name of PEBAX has made the greatest contribution to the general improvement of thermal - plastic elastomer family.
最近对热塑性弹性体产品家族总体增长贡献最大的是商品名为PEBAX的嵌段聚醚酰胺树脂。
3) polyamide resin
聚酰胺树脂
1.
Epoxy-bakelite-polyamide resin varnish;
环氧-酚醛-聚酰胺树脂掺混清漆
2.
Study on interface modifying of bamboo fiber reinforced polyamide resin composite;
竹纤维增强聚酰胺树脂复合材料界面改性
3.
The adsorption and desorption capability of five different macroporous resins LSA-20,LSA-21,LSA-30,D-101,AB-8 and polyamide resin in static state were studied by UV-Vis.
比较了五种大孔吸附树脂和聚酰胺树脂对阿尔泰狗哇花总皂苷的吸附与脱附性能。
4) polyamide resins
聚酰胺树脂
1.
This paper introduces a alcohol-soluble polyamide resins was prepared by co-polycondesation with dimer acid and diamine as primary raw.
介绍了一种由二聚酸和二元胺为主要原料制备而成的醇溶性聚酰胺树脂。
2.
This paper introduces the requirements of polyamide resins derived by dimer acids and diamines as primary raw,ap-plied printing ink and the situation at home and abroad and the trend of development.
介绍了由二聚酸与二元胺为主要原料生产的聚酰胺树脂用于油墨的条件、国内外情况及发展趋势。
3.
The technics of adsorption and elution of nuciferine with polyamide resins as adsorbent was studied.
探讨了聚酰胺树脂对荷叶碱的吸附和洗脱工艺。
5) polyamide
[英][pɔli'æmaid] [美][,pɑli'æm,aɪd]
聚酰胺树脂
1.
Study on the morphology and crystallization behavior of column chromatography polyamide
层析聚酰胺树脂的微观形态和结晶性能研究
2.
The thermodynamics and dynamics for adsorption of picric acid onto polyamide under static conditions were studied and the influence of temperature on the adsorption was also inspected.
在静态下,考察了温度对聚酰胺树脂吸附水溶液中苦味酸的影响,探讨了吸附的热力学、动力学规律。
3.
Then, the catechin is dissolved by 40% sulfuric acid solution (mass fraction) after being washed by water, and through the polyamide column.
用ZnCl2 作沉淀剂 ,当溶液pH值为 5 6～ 6 5时 ,将茶叶浸提液中的儿茶素以金属盐的形式沉淀 ,沉淀物经洗涤后 ,用质量分数为 4 0 %的硫酸溶解 ,然后将溶液直接加入聚酰胺树脂柱上 ,先用蒸馏水将Zn2 + ,Na+ 等无机离子除去 ,再用乙醇将茶多酚洗脱 ,洗脱液经浓缩、干燥 ,得到纯度高于 99%的高纯酯型儿茶素 ,提取率达 10 。
6) pPDA/ODA-PMDA block copolymer
嵌段共聚酰亚胺
1.
pPDA/ODA-PMDA block copolymers(b-PIs) with different segment length of two components were prepared.
通过控制2个组分的序列长度,制备了pPDA(对苯二胺)/ODA(4,4′-二氨基二苯醚)-PMDA(均苯四羧酸二酐)嵌段共聚酰亚胺(b-PI)。
补充资料：聚十三二酰十三二胺树脂
分子式：
CAS号：
性质：又称聚酰胺1313(polyamide 1313)或尼龙1313(nylon 1313)。相对密度1.01，熔点170～174℃，拉伸强度35～37MPa，弯曲强度33～43MPa，冲击强度250～290kJ/m2，洛氏硬度59～62，吸湿率(浸水24h)0.137％～0.175％，表面电阻率1015Ω，体积电阻率1014Ω·cm。由十三碳二胺和十三碳二酸缩聚制备。加工性好、宜作电缆护套，也可增强填充改性。
CAS号：
性质：又称聚酰胺1313(polyamide 1313)或尼龙1313(nylon 1313)。相对密度1.01，熔点170～174℃，拉伸强度35～37MPa，弯曲强度33～43MPa，冲击强度250～290kJ/m2，洛氏硬度59～62，吸湿率(浸水24h)0.137％～0.175％，表面电阻率1015Ω，体积电阻率1014Ω·cm。由十三碳二胺和十三碳二酸缩聚制备。加工性好、宜作电缆护套，也可增强填充改性。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条