1) exposure aperture
透光点
1.
The causes of occurrence of exposure aperture on color glazed glass was discussed and some helpful suggestions was proposed in this article .
分析了彩釉玻璃透光点产生的原因,提出了解决办法。
2) penetration points
透点
1.
The determination method for penetration points in light well dewatering is introduced and from three aspects: site geological conditions, dewatering equipments and error in pipe length the reasons caused the penetration points are analyzed; at the same time corresponding prevention and treatment measures are proposed.
介绍了判断轻型井点降水是否发生透点现象的方法 ,从施工现场地质条件、降水设备及井点管长度误差三方面 ,就发生透点的原因进行了分析 ,提出了相应的排除和防治措
3) sparkling
[英]['spɑ:klɪŋ] [美]['spɑrklɪŋ]
发光;透明点,玻璃花(纸病)
4) trifocal
[英][trai'fəukl] [美][traɪ'fokəl, 'traɪ,fo-]
三焦点透镜;三焦点的;三光眼镜
5) lens transmission
透镜透光率
6) central perspective projection
中点透视
补充资料:闭式单点、双点压力机
| |||||||
主要参数内容 | 国际先进 | 国内先进 | 国内一般 | 国内落后 | 评定方法及说明 | ||
(一)加工精度 | 参照GB10924-89、GB10933-89、JB5200-91 | ||||||
1、滑块下平面对工作台上平面的平行度(mm) | 30%精度储备 | 20%精度储备 | 达到规定值 | 大于规定值 | |||
0.02+0.10/100×滑块下平面的被测长度 | |||||||
2、滑块行程对工作台上平面的垂直度 | 30%精度储备 | 20%精度储备 | 达到规定值 | 大于规定值 | |||
0.05+0.02/100×滑块行程长度 | |||||||
(二)结构性能 | |||||||
1、离合器、制动器接通率,当滑块行程次数≤16次/分时为70%,≤25次/分时为60%,≤45次/分时为50% | 大于规定值10% | 大于规定值 | 达到规定值 | 达不到规定值 | |||
2、液压超负荷保险装置、微调装置、吨位指示器 | 全部具有 | 全部具有 | 部分具有 | 没有 | |||
(三)噪声dB(A) | |||||||
1、公称力≤400kN | ≤85 | ≤87 | ≤88 | >88 | |||
2、公称力>400kN | ≤87 | ≤88 | ≤90 | >90 |
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条