1) cementing temperature
胶结温度
2) gelation temperature
胶凝温度
1.
The aim of the present work is to investigate the characteristics including gelation temperature, sol-gel transition temperature (T_ s-g ), gel strength, stable viscosity, erosion and drug release behavior of the thermosensitive in situ gel which are composed o.
本文以泊罗沙姆Pluronic F127为温度敏感原位凝胶材料,考察了PluronicF127与Pluronic F68不同浓度处方对地塞米松磷酸钠温度敏感原位凝胶的胶凝温度、相转变温度、凝胶强度、稳态黏度、溶蚀和药物释放行为等特性的影响。
2.
The experimental results show that the gelation temperature at which G'= G", coincides with the gel point when the temperatu.
5-1℃/min,储能模量(G’)和耗能模量(C”)相等时的胶凝温度与按SY/T0541-94方法测定凝点基本一致,说明用小振幅振荡剪切温度扫描法来确定含蜡原油的凝点是可行的。
3.
The gelation extent and structure strength can be revealed by the viscoelastic parameters and gelation temperature measured by small amplitude oscillatory shear experiment.
结果表明,储能模量和耗能模量随测量温度的降低呈指数规律增加;存在使流变性恶化的“最差加热温度”;降温速率越高,测量温度下蜡晶结构强度和胶凝温度越低。
3) Gelation temperature
凝胶温度
4) rubber discharging temperature
排胶温度
1.
This method could forecast the rubber discharging temperature, discharging time and so on.
该方法可预测密炼机排胶温度、排胶时间等。
5) the temperature of compounded rubber
炼胶温度
6) temperature resistant structural adhesive
耐温结构胶
补充资料：铂电阻温度表(见电阻温度表)
铂电阻温度表(见电阻温度表)
表。bod旧nZu wendubiao铂电阻温度表见电阻温
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条