1) residual oil rate
残油率
1.
Based on a new extrusion-expanding pre-treatment technics,a mathematical model was developed to quantitatively analyze the residual oil rate of soy meal at different extrusion conditions including moisture of material,expanding temperature,die length,δ section length,and rotate speed of screw.
采用新型挤压膨化预处理工艺,通过建立数学模型系统的分析了物料水分、膨化温度、模孔长度、δ段长度、螺杆转速对粕残油率的影响,同时,确定出最适挤压参数为:物料水分10。
2.
In the work aimed to find ways to decrease the peanut protein residual oil rate aqueous extraction of peanut oil and protein,the effect of enzymatic hydrolysis conditions on the peanut protein residual oil rate was studied.
为降低花生水酶法制油的花生蛋白残油率 ,以花生含油蛋白水提液为研究对象 ,研究酶解花生蛋白条件对其残油率的影响。
2) residual oil content
干饼残油率
1.
5 to 92 t dehulled rapeseed kernel per day,and residual oil content in c.
5~92 t/d脱皮菜籽仁,在65℃温度下入榨,一次压榨干饼残油率小于17%;装机容量为99 kW。
3) residual oil rate of soybean meal
豆粕残油率
1.
The results show that the soybean's moisture is the most important factor,the residual oil rate of soybean meal can be decreased with the increase of heat temperature and extrusion pressure.
主要研究了用挤压膨化机加工大豆制得的膨化料坯浸出后 ,豆粕残油率随加工参数变化的情况。
4) concentration of residual oil
洗涤残油率
5) dry meal residual oil rate
干粕残油率
6) residue oil
残油
1.
Extraction of rice residue oil and composition analysis of its fatty acid
米渣残油的提取及其脂肪酸组成分析
2.
20% residue oil,the acid value and the peroxide value of crude oil were 4.
在本试验条件下,重现性好,粕中残油率不超过1。
3.
More than 37 components in the residue oil obtained from distillation of borneol from Sect.
采用GC/MS法对水蒸气蒸馏和精制龙脑过程中的残油进行分离和鉴定 ,共分离了 3 7种化合物 ,鉴定 3 4种化学成分 ,残油中最多的 2种化合物是樟脑 (3 3 。
补充资料：残油
分子式：
分子量：
CAS号：
性质：在石油加工中指直馏重油在减压蒸馏时蒸去润滑油后残余的更重的油料。也指由裂化石油所得的重油。
分子量：
CAS号：
性质：在石油加工中指直馏重油在减压蒸馏时蒸去润滑油后残余的更重的油料。也指由裂化石油所得的重油。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条