1) thermally charging hydrogen
热渗氢
2) hydrogenation
[,haidrədʒə'neiʃən]
渗氢
1.
The both microstructures of hot deformation and dehydrogenation of TCA alloy was researched in this paper.
研究了渗氢TC4钛合金热变形后及除氢处理后的显微组织。
2.
The phase composition and microstructure of TC4 alloy after hydrogenation(1.
本文研究了TC 4钛合金渗氢(1。
3.
The microstructure of Ti6Al4V alloy after hydrogenation has been investigated by XRD and TEM.
利用XRD,TEM研究了渗氢后Ti6Al4V合金的组织变化。
3) Hydrogen permeation
渗氢
1.
If hydrogen permeation was strengthened, a hydrogen concentration gradient was set up and a "river" pattern on the fracture surface was observed which indicates the gradually increased plastic deformation from the surface to the inner .
当渗氢量较低时，断裂方式主要由试样的应力状态所决定，发生近表面区的平面应力断裂和内部的平面应变断裂。
4) hydrogen permeation
氢渗
1.
And hydrogen permeation results indicate .
氢渗透结果指出,H800、H900以及H1000时效试片具有极为相近的氢渗特性,然而相对於其他试片,H1100试片却表现出较低的氢扩散率、氢通量以及较高的固溶量。
2.
The effect of Al-2O-3 particles added in Cd-Al-2O-3 composite electroplate on hydrogen permeation was probed by electrochemical method.
利用电化学方法探讨了在电镀镉及加入Al2 O3 微粒过程中 ,Al2 O3 微粒的加入量对其氢渗入量的影响。
3.
And hydrogen permeation results indicate .
氢渗透結果指出,H800、H900以及H1000時效試片具有極為相近的氢渗特性,然而相對於其他試片,H1100試片却表現出較低的氢擴散率、氢通量以及较高的固溶量。
5) hydrogen permeation
氢渗透
1.
The hydrogen permeation of 16Mn steel in a sea mud from the Bohai sea with and without sulfate reducing bacteria(SRB) was studied with an improved devnathan-stachurski′s electrolytic cell.
采用改进的devnathan-stachurski双电解池技术研究了16Mn钢在含硫酸盐还原菌(sulfate reducing bacteria,简称SRB)海泥和灭菌海泥中的氢渗透行为。
2.
The equations between 16MnR steel corrosion rate and steady current density of hydrogen permeation were used to calculate the wet H_2S corrosion rate of the interior of the equipment by detecting the hydrogen permeation.
钯合金膜氢传感器的信号稳定、可靠,由氢传感器检测氢渗透的稳态电流密度,通过16MnR钢的腐蚀速率随稳态氢渗透电流密度变化的方程,计算设备内部湿硫化氢腐蚀速率。
3.
The curves of hydrogen permeation in steels of A3,08F,16MnR and 20G were determined at temperatures between 293 K to 328 K by Devanathan-Stachurski cell.
在293 K~328 K的温度范围内,用Devanathan-Stachurski电池装置测定了氢在A3、08F、16MnR和20G钢中的氢渗透曲线,求得氢扩散系数与温度之间的阿仑尼乌斯方程,为监测钢在使用中氢的积累提供基本参数。
6) hydrogen-free carburizing
无氢渗碳
1.
The preparation processing parameter study of the double glow discharge plasma hydrogen-free carburizing on titanium alloy surface;
钛合金双层辉光放电离子无氢渗碳制备工艺研究
2.
Using the double glow plasma hydrogen-free carburizing method carry through surface strengthen to enhance titanium alloy surface intension,Can avoid brittleness.
采用双层辉光离子无氢渗碳的方法对钛合金进行表面强化处理,提高了钛合金的表面强度,改善了其耐磨性；同时避免了氢脆的产生。
3.
A carburized layer composed of hardness phase TiC and free state phase C were formed on titanium alloy Ti6Al4V surface by using the double glow plasma hydrogen-free carburizing which enhanced titanium alloy\'s wear resistance,and avoided hydrogen brittleness.
使用双层辉光离子无氢渗碳技术,在钛合金Ti6Al4V表面形成了一层包含高硬度相TiC和游离态C元素组成的表面改性层,用于提高钛合金的耐磨性,同时避免了氢脆的发生。
补充资料：渗渗
1.寒冷貌。 2.指因害怕而产生发冷的感觉。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条