1) mold filling
充模
1.
A new implicit numerical algorithm was proposed for mold filling simulation of RTM.
RTM充模分析的隐式方法需要迭代来决定树脂注满的区域。
2.
The effect of vibration field of the injection molding process on mold filling process of the disc mould is investigated.
探讨注射成型过程中振动力场对圆盘模腔充模过程的影响,建立起数学模型,推导出相应的功率表达式,分析了振动频率和振幅对圆盘模腔充模功率的影响,而且通过实验验证了振动力场的引入使得圆盘模腔充模功率降低。
3.
A local LU factorization method was proposed to solve pressure equation for mold filling in injection molding and was compared with iterative methods.
提出了一个LU局部分解方法来求解注射充模过程的压力方程,并与其他迭代方法进行了比较。
2) filling
[英]['fɪlɪŋ] [美]['fɪlɪŋ]
充模
1.
The influences of additional pressure losses at the entrance and the wall-slip velocity caused by the viscoelasticity of rubber on the process of filling were studied on the basis of injection molding of plastics, and a mathematical model of filling flow in the thin rectangular for rubber was set up.
借鉴塑料熔融注射技术，研究了胶料粘弹性引起的入口附加压力降和固体壁面滑移速度对充模过程的影响，从而建立了橡胶在薄矩形模腔内充模流动的数学模型。
3) molding filling simulation
充模模拟
4) Filling Behavior
充型模式
1.
Numerical Simulation and Analysis of the Influence of the Pattern Density on the Filling Behavior in Lost Foam Casting;
模样密度对消失模铸造充型模式影响的模拟计算
5) filling process
充模过程
1.
Numerical simulation on the filling process of water-assisted injection molding;
水辅助注射成型充模过程的数值模拟研究
补充资料：充炭黑充油丁苯橡胶
分子式：
分子量：
CAS号：
性质：同时含有炭黑和油的丁苯橡胶。性能和用途与充炭黑丁苯橡胶和充油丁苯橡胶相似。由冷聚丁苯胶乳与炭黑的水分散液和油乳液经混合、凝聚、洗涤、过滤、干燥等步骤制得。
分子量：
CAS号：
性质：同时含有炭黑和油的丁苯橡胶。性能和用途与充炭黑丁苯橡胶和充油丁苯橡胶相似。由冷聚丁苯胶乳与炭黑的水分散液和油乳液经混合、凝聚、洗涤、过滤、干燥等步骤制得。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条