1) fatty acid ethyl ester
硬脂酸酯
1.
The synthesis of fatty acid ethyl ester in THF catalyzed by lipase was studied.
用脂肪酶在四氢呋喃中催化合成硬脂酸酯。
2) L-ascorbyl stearate
VC硬脂酸酯
1.
The remaining ratio of L-ascorbyl stearate or D-isoascorbyl stearate in ethanol is measured by iodimetry to investigate their stability.
将VC硬脂酸酯和异VC硬脂酸酯溶解到乙醇中,利用碘量法测定不同时间、不同条件下它们的浓度。
3) PEG40 stearate
PEG40硬脂酸酯
1.
METHODS PEG40 stearate and PEG100 stearate modified NLC (PEG40-NLC, PEG100-NLC) were prepared by melt emulsification and homogenization technique.
方法采用“熔融乳化-高压均质法”制备以PEG40硬脂酸酯及PEG100硬脂酸酯修饰的纳米脂质载体(PEG40-NLC及PEG100-NLC);测定PEG40-NLC及PEG100-NLC的开环百分率及固定水化层厚度;考察二者的体外释放及大鼠体内的药动学参数。
4) PEG100 stearate
PEG100硬脂酸酯
1.
METHODS PEG40 stearate and PEG100 stearate modified NLC (PEG40-NLC, PEG100-NLC) were prepared by melt emulsification and homogenization technique.
方法采用“熔融乳化-高压均质法”制备以PEG40硬脂酸酯及PEG100硬脂酸酯修饰的纳米脂质载体(PEG40-NLC及PEG100-NLC);测定PEG40-NLC及PEG100-NLC的开环百分率及固定水化层厚度;考察二者的体外释放及大鼠体内的药动学参数。
5) Rutin stearate
芦丁硬脂酸酯
1.
rutin stearate ester (RS), laurate ester (RL) and caporiate ester (RC), in diluted aqueous sodium hydroxide were investigated by measuring their surface tensions.
芦丁硬脂酸酯(RS)、芦丁月桂酸酯(RL)和芦丁正己酸酯(RC)弱碱性水溶液的表面饱和吸附量分别为:1·71×10-11、1·35×10-11和1·41×10-11mol/cm2,它们的临界胶束浓度(CMC)分别是3×10-3、1·65×10-3和1·3×10-3mg/mL。
6) D-isoascorbyl stearate
异VC硬脂酸酯
1.
The remaining ratio of L-ascorbyl stearate or D-isoascorbyl stearate in ethanol is measured by iodimetry to investigate their stability.
将VC硬脂酸酯和异VC硬脂酸酯溶解到乙醇中,利用碘量法测定不同时间、不同条件下它们的浓度。
参考词条
补充资料：2,2,6,6-四甲基-4-哌啶硬脂酸酯
分子式：C27H53NO2
分子量：423.72
CAS号：167078-06-0
性质：
分子量：423.72
CAS号：167078-06-0
性质：
说明：补充资料仅用于学习参考，请勿用于其它任何用途。