1) NC system of the cutting torch
割炬数控系统
2) wire-electrode cutting numerical control system
线切割数控系统
1.
Wire-electrode cutting numerical control system which is an important embranchment of numerical control system is developing continuously,and establishing consummate exploitation model redounds to elevating the developing efficiency and quality of wire-electrode cutting numerical control system.
线切割数控系统作为数控系统中的一个重要分支正不断发展。
3) NC WEDM autoprogramming system
线切割数控编程系统
1.
In this paper, the authors develop an universal serial interface architecture based on a NC WEDM autoprogramming system, providing a solution to the instruction transportation and control of NC WEDM group.
在线切割数控编程系统的基础上针对多台线切割数控机床的指令传递及控制问题构筑了一个通用串行接口体系 ,通过应用虚拟设备驱动系统 (WDM)软件技术及USB硬件规范 ,对线切割数控系统进行了改进 ,使整个数控系统具有满意的可控性及先进性。
4) WEDM-CNC
线切割加工数控系统
1.
It is of great practical importanceto develop a low-cost, high efficiency open WEDM-CNC system.
数控系统是数控机床的核心,开发出低成本、高效率的开放式电火花线切割加工数控系统具有十分重要的现实意义。
5) flare system
火炬系统
1.
And a conclusion that old and new platforms of SZ36-1 oil field can share flare system in normal condition and blockage condition,meet special conditions in fire situation is given.
根据API RP 521规范要求,应用专业的火炬计算软件Flaresim程序,分别校核各种工况的马赫数、热辐射强度、火炬分液罐尺寸及背压,得出绥中36-1油田新老平台在正常工况和堵塞工况下可以共用火炬系统,在火灾工况下满足一定条件也可以共用火炬系统,最后对计算结果进行了分析,给出了结论和建议。
6) cutting torch
割炬
1.
Usage and maintenance of welding and cutting machines(73)——Typical usage and maintenance of welding torch and cutting torch;
焊接与切割设备的使用和维修(七十三)——焊炬、割炬的使用与维修
2.
New type of cutting torch based on water vapor plasma arc;
一种基于等离子弧的水蒸气割炬
补充资料：电炬
1.电灯。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条